SAT
LOCATING SATELLITES
The function allows you to search for satellites whose transponder frequencies are unknown. The frequency range from 1000 to 2100 MHz is continuously scanned for reception signals. If a reception signal is detected, the reception level is indicated in the display in the form of an increasing or decreasing bar.
The 
buttons allow you to set the measurement
range to three sensitivity levels.
A bearing sound enables you to monitor the level. The pitch of the bearing sound is proportional to the received signal level. The volume of the bearing sound can be adjusted using
the 
volume buttons.
Command overview 
Switch to the
Switch the measurement range, the bar graph and the bearing sound:
Level range 1: Large input levels
Level range 2: Medium input levels
Level range 3: Small input levels
Exit this mode
LC display:
•Level range 2: Medium input level
•SAT mode
•Bar graph display with bearing sound
Example
Launching the “Find satellite” function:
•Press the 
button.
•Slowly turn the antenna until a level tendency can be seen on the bar display
•Slowly turn the antenna until the bar display reaches its maximum
•If necessary, decrease or increase the sensitivity using the 
and 
buttons
•Press the 
button to exit this function
33