Kathrein MSK 125 manual Analogue Satellite Reception, SAT ANALOGUE/DVB-S2 Switch

Page 18

SAT

ANALOGUE SATELLITE RECEPTION

In SAT mode the MSK 125 can be adjusted to “Analogue” and “DVB S(2)” reception types.

SAT ANALOGUE/DVB-S(2) SWITCH

Press once	= SAT analogue
Press again	= DVB-S(2)
Press again	= SAT analogue again

FREQUENCY DISPLAY AND ENTRY

To measure the level of a reception signal, you must ﬁrst enter the desired frequency. The LC display indicates the frequency and the measured level. The frequency can be entered from 920 MHz to 2150 MHz in 100 kHz intervals.

COMMAND OVERVIEW OF SAT FREQUENCY ENTRY

Switch to satellite reception (analogue or digital)

Example

Note

... Enter frequency

Frequency can be changed in 100 kHz intervals

Conﬁrm entry

LC display:

•Frequency: 1288.0 MHz

•Operating mode: SAT

•Level: 66.5 dBµV A (A = analogue)

To enter the frequency 1508 MHz:

Press

LC display:

•Frequency: 1508.0 MHz

•Operating mode: SAT

•Level: 86.5 dBµV (A = analogue)

A “+” or “-” on the display means that the MSK 125 has not been

adjusted precisely to the desired carrier. Use the

and

buttons to reﬁne the frequency for optimum reception. A vertical line on the display indicates optimum frequency adjustment.

Complete your frequency entry by pressing the button.

The most recent frequency setting remains even after you switch the MSK 125 off if it has been entered with digits and conﬁrmed

by pressing .

18

Image 18

Contents MSK General Safety Instructions FOREWORD/IMPORTANT InstructionsValidity of this Operating Manual Contents FM Measurement Customer Service Storing Device SettingsMaintenance Features Technical Data Technical AppendixSafety Instructions Safety InstructionsMeaning of Symbols Product PackageFunctionality Function 8PSKTFT Colour Display Operating and Display ElementsLC Display LED DisplayTFT colour display Source selection Measurements LC displayOverview of Keypad Commands ButtonInput block Alphanumeric input Operating and Display Elements Front View Fan Ear phones Loudspeakers Battery fuse DC supplyConnections Side ViewUSB Port External DC Power SupplyRF Input Socket SD CardSwitch on Switching OFF Setup Menu Setup Menu SettingsGetting Started Parameter Setting Mains and Battery OperationDefault Setup Settings AT Time of Shipment Mains OperationBattery Operation SAT SAT ANALOGUE/DVB-S2 SwitchCommand Overview of SAT Frequency Entry Analogue Satellite ReceptionLNB Voltage and 22 KHZ CHANGE-OVER Following voltages can be called up via button commandCommand overview for LNB voltage Button LNB voltageSound Carrier Frequency Setting SAT Analogue Level MeasurementLevel overﬂow and underﬂow Frequency in MHz Bandwidth Select Sound CarrierDigital SAT Reception Called up via button command Following voltages can be ButtonCommand overview for LNB voltage Setting DVB-S2 Demodulation Parameters Diseqctm Digital Satellite Equipment ControlSAT DVB-S2 Level Measurement Command Overview for Diseqctm Button Hex codeSAT-CTRL menu DiSEqCTM menu Command Overview for Framing Byte Command Overview for Address ByteHex Byte Description Switch Read switching status ﬂag commited port Command Overview for Command ByteHex Command ID Description ByteCommand Overview for Data Byte Orbit Polarisation Switch Position Data Byte Low BandList of Single Cable Diseqctm Command Command Overview for Simple DiseqctmSimple DISEQCTM, Tone Burst Calling up DVB-S2 measurement DVB-S2 MER, BER and Offset MeasurementMpeg Image Representation in DVB-S2 Press to exit digital receptionCommand overview Locating SatellitesCommand overview for ﬁnding Finding Individual Reception FrequenciesTV Measurement Analogue CABLE/DVB C SwitchHF Standard Switch Analogue Cable Demod Menu Analogue TV Cable ReceptionCommand Overview for TV Channel Entry Channel Display and EntryFrequency Display and Entry Command Overview for TV Frequency Entry Cable Analogue Level MeasurementLevel Overflow and Underflow Command Overview for Measure TV Audio Carrier FrequencyAudio Carrier Spacing and Level StandardSelect Soundcarrier Digital TV Cable Reception Channel Display and Entry Setting DVB-C Demodulation Parameters DVB-C/DVB-T/H MER, BER and Offset Measurement Level Measurement of DVB-C/DVB-T/H SignalsLC display for DVB-C signals To call up DVB-C/DVB-T/H measurementMpeg Image Representation in DVB-C HF Standard Switch Analogue TERRESTRIAL/DVB T/H SwitchHF Standard Switch Terrestrial Analogue Terrestrial TV ReceptionChannel Display and Entry Command Overview for TV Frequency Entry Select the required HF bandwidth by using the digit buttons Setting DVB-T/H Demodulation ParametersHF Standard Switch DVB-T Digital Terrestrial TV ReceptionChannel Display and Entry DVB-C/DVB-T/H MER, BER and Offset Measurement LC display for DVB-T signals Mpeg Image Representation in DVB-TFinding Individual Reception Frequencies Nicam Audio BIT Error Rate Measurement FM Measurement FM SwitchCommand Overview for FM Frequency Entry Level MeasurementCommand Overview for Find Spectrum Measurement SAT SpectrumTV Spectrum Spectrum Measurement FM Spectrum Deleting Device Settings Storing Device SettingsStoring Device Settings TFT display LC displaySpectrum Memory Full Only 10 Spec. Possible Storing Measurement ResultsStoring Measurement Results in the Device Memory TFT displayDeleting Measurement Results from the Device Memory Storing Measurement Results on the SD CardStoring Measurement Results Data Logger Entering the Start Line for Automatic MeasuringStarting and Interrupting Automatic Measuring Entering the Stop Line for Automatic MeasuringStoring the Data Logger Measurement Results on the SD Card MessageMaintenance Customer Service Technical Customer SupportFeatures Technical Data RF componentLevel measuring component SIGNAL-TO-NOISE Ratio Technical Appendix+14.1 dB Command SET for EXR 20 Kathrein Matrix Diseqctm Commands for Kathrein MatricesCommand SET for Kathrein Matrices Command SET for EXR 22 Kathrein MatrixChannel Tables Channel UND Frequency TABLE, Standard B/G Frequency in MHZChannel UND Frequency TABLE, Standard L Frequency in MHZ VHF UHFChannel UND Frequency TABLE, D/K Standard Frequency in MHZ VIIChannel UND Frequency TABLE, I Standard Frequency in MHZ Oscillation frequency is made up as follows Calculation of SAT if Frequency Using the MSKThis is done as follows Hence the values for ARD Das Erste arePage Page 936.3474/A/0409/ZWT Technical data subject to change