Woods Equipment BH6000 manual Crushing Hazard

Page 11

SAFETY & INSTRUCTIONAL DECALS

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Replace Immediately If Damaged!

"

2 - PN 1008363

WARNING

TO AVOID SEVERE INJURY OR DEATH,

￿ Read Operator's Manual (Obtain from dealer or, in the United States and Canada call 1-800-319-6637) and follow all safety rules.

￿ Make sure all safety decals are installed and readable. Replace if damaged. ￿ Make sure shields and guards are properly installed. Replace if damaged.

￿ A minimum 25% of tractor and equipment weight must be on tractor front wheels with backhoe in transport position.

￿ When using backhoe, always sit in backhoe seat; Keep others out of operator, stabilizer, and maximum bucket swing areas.

￿ Backhoe digging forces can lift and turn tractor over. Make sure stabilizer pads are on firm ground and avoid soft or steep banks.

￿ Consult local utilities before digging. Know location of and avoid contact with all under- ground cables, pipelines, overhead wires and other hazards in digging area.

￿ Never allow riders on tractor or backhoe.

￿ Before transport, attach Slow Moving Vehicle (SMV) sign and engage transport locks. ￿ Before leaving equipment unattended, raise boom and install transport locks, relieve

pressure on dipperstick and bucket, shut engine off, and remove key.

3 - PN 1008364

1008363

DANGER

CRUSHING HAZARD

￿Never use unless backhoe manufacturer's sub-frame has been installed as instructed in Operator's Manual. (Obtain manuals from dealer or, in the United States and Canada call 1-800-319-6637.)

￿Do not modify or substitute any part of mounting kits or backhoe.

Failure to follow these instructions can result in severe injury or death from backhoe

being thrust upward, forward, or rearward by digging forces.

1008364

MAN0306 (Rev. 5/23/2008)

Safety 11

 

 

Image 11
Contents Backhoe To the Dealer IntroductionTable of Contents English Metric Bucket Description Illustration BH6000 SpecificationsIntroduction Backhoe Components General InformationTraining SafetySafety Rules InstallationTransportation OperationStorage MaintenanceLock Safety & Instructional DecalsCrushing Hazard Operation OperationControl Handle Operation Position the MachineTrenching and Excavating Start ExcavationFill Bucket Dump and Return CycleThumb Operation Side Slope Trenching or ExcavatingTransport Backhoe and Tractor on a Trailer Transport and Swing Lock InstallationTransport Backhoe Tie Down Location Remove and Store BackhoePRE-OPERATION Check List Owners Responsibility Hydraulic Hoses and Fittings Owner ServiceOwner Service Relief ValveLubrication Points LubricationPeriodically or Before Extended Storage TroubleshootingCleaning After Each UseHydraulic Valve Repair Dealer ServiceDealer Service Assemble Spool RepairDisassemble Boom, Dipperstick, Bucket & Stabilizer Cylinders Adjust Control Valve LinkageHydraulic Cylinder Repair General Hydraulic Repair InformationSwing Cylinder Install Stabilizer AssemblyAssembly General Assembly InstructionsInstall Backhoe Brackets Install Dipperstick CylinderInstall Bucket Install Hydraulic HosesStabilizer Pad Point Down Install Optional Stabilizer Street PADDelivery Check List DEALER’S Responsibility Dealer Check ListsDealer Check List PRE-DELIVERY Check List DEALER’S ResponsibilityMAN0306 Rev /23/2008 Parts Parts IndexBH6000 Main Frame Assembly Part QTY Description BH6000 Dipperstick Assembly BH6000 Boom Assembly BH6000 Cylinders BH6000 Valve Controls & HardwareBH6000 Control Valve BH6000 Hoses & Fittings Optional Stabilizer Street PAD BH6000 Hoses & Fittings Parts ListBH6000 Mechanical Thumb Metric Series Bolt Torque ChartSAE Series Torque Chart AppendixAbbreviations Bolt Size ChartIndex IndexWarranty Rev /23/2005 MAN0306