Woods Equipment BH6000 manual Install Optional Stabilizer Street PAD, Stabilizer Pad Point Down

Page 28

INSTALL OPTIONAL STABILIZER STREET PAD

1.Remove cotter pins, headless pin, and stabilizer pad from the end of each stabilizer arm.

NOTE: On earlier stabilizer arms the mounting holes are not available, holes will have to be drilled. See Figure 21 to locate and drill two 25/64” (.391”) holes on the back side (tractor side) of the stabilizer arms.

Figure 21. Mounting Hole Location

2.Attach rubber strap (3) to the back side (tractor side) of the stabilizer arm using two carriage bolts (11), reinforcement strap (4) and flange whiz nut (13). See Figure 22.

3.Attach stabilizer pad (1) to the end of stabilizer arm using headless pin (5) and two cotter pins (10).

1.Stabilizer pad

3.Rubber strap

4.Reinforcement strap

5.Headless pin 1 x 5.84

10.3/16 x 1-1/2 cotter pin

11.3/8 NC x 1-1/2 carriage bolt

13.3/8 NC Flange whiz nut

Figure 22. Stabilizer Street Pad Installation

4.Rotate stabilizer pad over and past rubber strap with the points down for use in soil conditions. See Figure 23.

5.Rotate stabilizer pad with rubber pads down for use on hard surfaces.

Figure 23. Stabilizer Pad - Point Down

™

28 Assembly

MAN0306 (Rev. 5/23/2008)

 

 

Image 28
Contents Backhoe Introduction To the DealerTable of Contents BH6000 Specifications English Metric Bucket Description IllustrationIntroduction General Information Backhoe ComponentsSafety Safety RulesInstallation TrainingOperation TransportationMaintenance StorageSafety & Instructional Decals LockCrushing Hazard Operation OperationPosition the Machine Control Handle OperationStart Excavation Fill BucketDump and Return Cycle Trenching and ExcavatingSide Slope Trenching or Excavating Thumb OperationTransport Transport and Swing Lock InstallationTransport Backhoe and Tractor on a Trailer Remove and Store Backhoe Backhoe Tie Down LocationPRE-OPERATION Check List Owners Responsibility Owner Service Owner ServiceRelief Valve Hydraulic Hoses and FittingsLubrication Lubrication PointsTroubleshooting CleaningAfter Each Use Periodically or Before Extended StorageDealer Service Dealer ServiceHydraulic Valve Repair Disassemble Spool RepairAssemble Adjust Control Valve Linkage Hydraulic Cylinder RepairGeneral Hydraulic Repair Information Boom, Dipperstick, Bucket & Stabilizer CylindersSwing Cylinder Assembly AssemblyGeneral Assembly Instructions Install StabilizerInstall Dipperstick Cylinder Install BucketInstall Hydraulic Hoses Install Backhoe BracketsInstall Optional Stabilizer Street PAD Stabilizer Pad Point DownDealer Check Lists Dealer Check ListPRE-DELIVERY Check List DEALER’S Responsibility Delivery Check List DEALER’S ResponsibilityMAN0306 Rev /23/2008 Parts Index PartsBH6000 Main Frame Assembly Part QTY Description BH6000 Dipperstick Assembly BH6000 Boom Assembly BH6000 Valve Controls & Hardware BH6000 CylindersBH6000 Control Valve BH6000 Hoses & Fittings BH6000 Hoses & Fittings Parts List Optional Stabilizer Street PADBH6000 Mechanical Thumb Bolt Torque Chart SAE Series Torque ChartAppendix Metric SeriesBolt Size Chart AbbreviationsIndex IndexWarranty Rev /23/2005 MAN0306