Woods Equipment BH6000 manual Lubrication Points

Page 20

LUBRICATION

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

Do not let excess grease collect on or around parts, particularly when operating in sandy areas.

Figure 16 shows lubrication points for the backhoe.

It is recommended that all fittings be lubricated daily or every eight hours of operation. In very wet or dry condi- tions, lubricate every four hours of operation.

Use an SAE multi-purpose type grease for all locations shown unless otherwise specified. Be sure to clean fit- ting thoroughly before using grease gun. One good pump of most guns is sufficient.

Position backhoe for easy lubrication by placing boom and dipperstick at 90° to each other with bucket cutting edge vertical and teeth resting on ground. Lower stabi- lizers to lubricate cylinders.

1.Bucket link

2.Bucket pivot

3.Bucket cylinder rod end

4.Guide link pivot

5.Bucket cylinder base end

6.Dipperstick cylinder rod end

7.Dipperstick pivot

8.Boom cylinder base end

9.Boom cylinder rod end

10.Boom pivot

11.Swing frame upper pivot

12.Swing frame lower pivot

13.Stabilizer cylinder rod end

14.Stabilizer cylinder base end

15.Stabilizer cylinder base end (2X)

16.Stabilizer cylinder rod end (2X)

17.Stabilizer pivot (2X)

Figure 16. Lubrication Points

20 Owner Service

MAN0306 (Rev. 5/23/2008)

 

 

Image 20
Contents Backhoe Introduction To the DealerTable of Contents BH6000 Specifications English Metric Bucket Description IllustrationIntroduction General Information Backhoe ComponentsSafety Safety RulesInstallation TrainingOperation TransportationMaintenance StorageSafety & Instructional Decals LockCrushing Hazard Operation OperationPosition the Machine Control Handle OperationStart Excavation Fill BucketDump and Return Cycle Trenching and ExcavatingSide Slope Trenching or Excavating Thumb OperationTransport Backhoe and Tractor on a Trailer Transport and Swing Lock InstallationTransport Remove and Store Backhoe Backhoe Tie Down LocationPRE-OPERATION Check List Owners Responsibility Owner Service Owner ServiceRelief Valve Hydraulic Hoses and FittingsLubrication Lubrication PointsTroubleshooting CleaningAfter Each Use Periodically or Before Extended StorageHydraulic Valve Repair Dealer ServiceDealer Service Assemble Spool RepairDisassemble Adjust Control Valve Linkage Hydraulic Cylinder RepairGeneral Hydraulic Repair Information Boom, Dipperstick, Bucket & Stabilizer CylindersSwing Cylinder Assembly AssemblyGeneral Assembly Instructions Install StabilizerInstall Dipperstick Cylinder Install BucketInstall Hydraulic Hoses Install Backhoe BracketsInstall Optional Stabilizer Street PAD Stabilizer Pad Point DownDealer Check Lists Dealer Check ListPRE-DELIVERY Check List DEALER’S Responsibility Delivery Check List DEALER’S ResponsibilityMAN0306 Rev /23/2008 Parts Index PartsBH6000 Main Frame Assembly Part QTY Description BH6000 Dipperstick Assembly BH6000 Boom Assembly BH6000 Valve Controls & Hardware BH6000 CylindersBH6000 Control Valve BH6000 Hoses & Fittings BH6000 Hoses & Fittings Parts List Optional Stabilizer Street PADBH6000 Mechanical Thumb Bolt Torque Chart SAE Series Torque ChartAppendix Metric SeriesBolt Size Chart AbbreviationsIndex IndexWarranty Rev /23/2005 MAN0306