Figure 9. Thumb in Storage Position
NOTE: Do not operate thumb using these hole posi- tions. Damage to thumb will occur.
Figure 10.
TRANSPORT
Always engage swing and boom transport locks and attach Slow Moving Vehicle (SMV) sign before transporting backhoe.
Power unit must be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in death from being run over or crushed. Keep foldable ROPS system in “locked up” position at all times.
Never leave equipment unattended with engine running or with bucket in raised position. Always engage swing and boom transport locks, relieve system pressure by operating controls, and remove ignition key before leaving equipment.
Transport and Swing Lock Installation
NOTICE
■Before operating backhoe, disengage transport lock bar and store swing lock pin. Push transport lock bar down fully to prevent damage.
Engage transport lock by fully retracting boom and dip- perstick. Position transport lock bar (1), located on right side of swing frame, over transport lock pin (2).
Center boom from side to side and install swing lock pin (3) through swing frame plate (4) and main frame. Secure swing lock pin (3) with a safety pin (5) as shown.
Always raise stabilizers before transporting backhoe.
1.Transport lock bar
2.Transport lock pin
3.Swing lock pin
4.Swing frame plate
5.Safety pin
Figure 11. Transport and Swing Lock Installation
Transport Backhoe and Tractor on a Trailer
The backhoe
Insert chain through holes provided and secure to trailer. See Figure 12.
16 Operation | MAN0306 (Rev. 5/23/2008) |
|
|