Extron electronic manual Using the AVT 200HD IR Remote Control, Executive Mode Menu Flow

You can access the Exec Mode Select menu when any other menu or submenu is displayed. To select an executive mode:

1.Press the Menu and Next buttons simultaneously and hold them until the LCD window displays the Exec Mode Select menu with the name of the current executive mode (approximately 3 seconds).

2.Rotate either Adjustment knob until the desired mode name appears in the LCD window.

3.Press the Menu or Next button to return to the default cycle or wait for the LCD display to time out.

Default	or	[ANY MENU]
Cycle

	Menu + Next
Menu	EXEC MODE SELECT
	DISABLE

Use either Adjustment knob to select an executive mode.

•DISABLE (Default)

•COMPLETE

•VOLUME ONLY

•IR LOCKOUT

Figure 26. Executive Mode Menu Flow

Using the AVT 200HD IR Remote Control

The optional hand-held AVT 200HD IR Remote Control lets you remotely perform many of the functions that are also available through the front panel, SIS commands, the Windows-based control software, or the embedded web pages. The AVT responds to commands from the remote control as if the corresponding front panel button were pressed or the corresponding SIS command or software selection were entered.

From a distance of no more than 30 feet (9.1 m), the remote control sends infrared (IR) signals to the AVT 200HD through the infrared remote sensor, located on the front panel to the left of the LED channel display. The IR sensor can receive the signal if it is sent from within a 40 degree arc to the right or left of direct line of sight between the remote control and the AVT receiver. See the diagram on the next page.

AVT 200HD Tuner • Operation 32