Extron electronic AVT 200HD Unit Reset Menu Resetting from the Front Panel, Unit Reset Menu Flow

Unit Reset Menu (Resetting from the Front Panel)

Three modes of reset can be initiated from the AVT 200HD front panel.

VIEW

COMM SETTING

Menu

UNIT	Next	FACTORY	Next	PRESS NEXT
RESET		RESET		TO RESET
	Menu		Turn either Adjustment knob
Default			to select a reset mode.
Cycle		• FACTORY RESET		Next
		• RESET USER SETTINGS
		• CLEAR CH & PRESET LIST

RESETTING UNIT

PLEASE WAIT..

Figure 24. Unit Reset Menu Flow

To reset the unit using the front panel menus:

1.Press the Menu button repeatedly until Unit Reset is displayed on the LCD screen.

2.Press Next to go to the Unit Reset submenu.

3.Rotate either Adjustment knob to display the reset options:

•Factory Reset: Restores all settings to the defaults that were set at the

factory except the IP settings. (This selection is equivalent to the SIS command E ZXXX; see the Total reset command in the “Command/response Table for SIS Commands,” “Remote Configuration and Control” section.)

•Reset User Settings: Resets all settings except the scanned channels and presets.

•Clear Ch & Preset List: Erases scanned channels and presets.

4.When the desired reset option is displayed on the LCD screen, press Next. The LCD screen displays Press Next to Reset.

5.Press Next to start the reset. While the unit is being reset, the LCD screen displays

Resetting Unit Please Wait.

When the reset is complete, the LCD display returns to the default cycle if the channel list has not been removed. If the channel list has been deleted, the [Source] Channel List Empty and Press Up Button to Start Scan messages alternate on the LCD screen.

NOTE: You can perform resets using:

• The Reset button (see “Resetting from the Rear Panel,” later in this section)

• SIS commands (see the Resets commands in the “Remote Configuration and Control” section)

• The Windows-based control software (see the program help file)

AVT 200HD Tuner • Operation 28