Extron electronic AVT 200HD manual Output Setup section, Executive Mode

Page 88

Editing or deleting a preset

To edit a preset:

1.In the Presets section, select a preset to edit.

2.Click the Edit button. The preset number, channel number, and name of the selected preset are displayed in the Save Preset section.

3.In the Save Presets fields, make the desired changes to the preset number or name. (You cannot change the channel number.)

4.In the Save Preset section, click Save. The changes to the preset appear in the Presets list.

NOTE: If you change a preset number, a new preset is added for the same channel. It does not replace the existing preset for that channel. In the

example above, channel 30.1 is now saved as two presets: P05 and P10.

To delete a preset:

1.In the Presets section, selected the preset to be deleted.

2.Click the Delete button. The selected preset name is removed from the list and from

AVT memory.

Output Setup section

In this section, select the radio buttons as desired for the following video and audio settings:

Aspect Ratio (16x9 or 4x3)

Display Mode:

Fill — The image fills a 16x9 screen. If the video image is 4x3, it is stretched horizontally to fit the larger screen.

Follow (default) — The aspect ratio of the output image follows that of the source (also called “normal” mode).

A 4x3 video image is framed to a 16x9 display area, retaining its original aspect ratio but with vertical gray or black bars on both sides of the screen. A 16x9 image is framed to a 4x3 area, with its original aspect ratio but with horizontal gray or black bars at the top and bottom of the screen.

Zoom — The image is evenly stretched both horizontally and vertically, until the picture fills the entire width of the screen.

Output Resolution (video)

Digital Output (audio)

Executive Mode

Select the radio button for the desired front panel lock mode or select Off to disable executive mode.

AVT 200HD Tuner • HTML Configuration and Control

82

Image 88
Contents AVT 200HD Safety Instructions English FCC Class a Notice Conventions Used in this Guide Contents Html Configuration About this Guide FeaturesAbout the AVT 200HD Tuner AVT 200HD Tuner Introduction Application Diagram Application Diagram for the AVT 200HDInstallation Installation OverviewVideo Output Connectors Rear Panel FeaturesComposite and S-video stacked video output connectors Audio Output Connectors Analog audio output connectorsRemote Configuration and Control Connectors Input ConnectorDigital audio output connectors Control Connections Wiring for RS-232 ControlEthernet Connection Wiring for IR Control Wiring the IR LinkConnecting to the USB Port Connecting the AVT 200HD to the IR LinkFound New Hardware Wizard Opening Screen AVT 200HD Tuner Installation Front Panel Features AVT 200HD Front PanelHdcp Compliance NBC-4LAPowering On Power-up and Default Cycle Screens ExampleMenus on the LCD Screen Using the menusMenu System Overview Menu flow diagram AVT 200HD Menu FlowChannel Setup Menu Selecting the signal sourceScanning for channels Option Scans forScanning Channels with long minor numbers CableOutput Configuration Menu Selecting tune or preset modeSaving presets Not available via the front panel Selecting a channelRecalling presets Selecting the output resolution and refresh rateSelecting the display mode Resolution CompositeSelecting the display aspect ratio Simultaneous Video OutputAudio Configuration Menu Selecting the closed caption serviceComm Setting Menus Comm Setting Menu FlowViewing serial port and IP settings Configuring the serial port and IP parametersUnit Reset Menu Resetting from the Front Panel Unit Reset Menu FlowResetting from the Rear Panel Volume ControlExiting the Menu System Reset Modes Summary Activation Result Purpose/Notes Exec Mode Select Disable Locking and Unlocking the Front Panel Executive ModesUsing the AVT 200HD IR Remote Control Executive Mode Menu FlowInstalling batteries in the AVT 100 Remote Area for Remote Signal ReceptionButtons on the AVT 200HD Remote Control Buttons on the AVT 200 Remote ControlSelecting a Channel or Preset Using the IR Remote Control Channel Selection buttons 0 throughLocking IR Remote Control Access Using the On-screen Display OSDIntroductory Display Volume Level Display Channel Information DisplayProgram Guide Serial Port USB PortEthernet Port Ethernet CableIP Address Connection TimeoutsEstablishing an Ethernet Connection Using SIS Commands Tuner-initiated MessagesChip Security for Parental Control Copyright message With an RS-232 connectionError Response References Tuner Error ResponsesUsing the Command/Response Tables for SIS Commands Symbol Definitions for AVT 200HD Specific Commands Special CharactersX1@ X1#X2@ X2# X2% X3@ X3#Command/Response Table for AVT 200HD SIS Commands EX!*X@TVSLX!*X@TVCH EX!*X@TVCHX2%TVPR EX2RATE EX2%NGEX2&OPOL EX1TVOS EX1TVTMEX1TVPG X1 Tvcc X1% FsccX1% X1 FsccX1&FSCC X1*FSCCX2*FSCC ExafmtChip Setup Parental Control EX* LangX1$ VolX1$ X3@Chip Setup X3@*X1VCHPX3@*X2@VCHP X2@$ Tvst Other SettingsTvst ‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘ Executive Mode Front Panel Lockout Information RequestsResets EZIX4# Symbol Definitions for IP-specific CommandsX5# X5$ X6# X6$X7# X7$X8# X8$EX4!CP Command/Response Table for IP-Specific SIS CommandsEX!CE EX5@CN ECNEX5#CT ECTEDH EX5$CIECI ECHBmdX9% ,X5$ EX4@ *X10# *X10$ PB BptX4@ *X5EX7$ ,X5$ ID EdiX7$ *X5$ *X4@ X7$ = 0EX4@MH EMHEX4@MD EMDEX7$ ,X7% ,X7 ,X7& E EX7$ ,X7% ,X7 ,X7*X7& E EvtX7$ ,X7% ,X7 ,X7EvtX7$,X7%,X7, string EX7$ ,X7% ,X7 ,X8 FEDownloading and Installing the Software from the Web Accessing the AVT 200HD Configuration & Control SoftwareComputer System Requirements Installing the Software from the Disc Software Button on the DVD Opening ScreenCommunication Setup Window with Telnet Tab Starting the SoftwareRS232 Connection Tab Setup Tab on the Main Window Using the Configuration & Control Program Help File Updating the FirmwareExtron Firmware Loader Window for AVT 200HD Firmware Update in Progress Accessing the Web Pages HtmlExample of a Network Password Dialog Box Special CharactersSystem Status System StatusConfiguration Pages System SettingsIP Settings Fields Unit Name fieldDate/Time Settings Fields Date/Time Settings FieldsTuner Settings Tuner SettingsEdit Channels and Presets section Channel Scan sectionTo hide a channel To show a hidden channelOutput Setup section Executive ModeSetting a password PasswordsRemoving passwords Firmware Upgrade Firmware UpgradeChoose File Window with a Firmware File Selected File Management Uploading FilesAdding a Directory Other File Management ActivitiesControl Pages User ControlAdjusting the volume Selecting a presetKeypad Closed Captioning Closed CaptioningChip Text Size Text Style Text Fill Text ColorMovie Rating Parental Control section Chip ScreenTV Rating Parental Control section Maximum Allowed TV Rating for Ages sectionChange PIN section Specifications Signal processingRF video input Video output analogVideo output digital SyncAudio output analog Audio output digitalPower VAC to 240 VAC, 50-60 Hz, 25 watts, internal GeneralPart Numbers and Accessories Optional AccessoriesIncluded Parts CablesMounting the Tuner Rack Mounting ProcedureUL Guidelines for Rack Mounting What is an IP Address? IP AddressingChoosing IP Addresses Class Name Valid Address Range Identifier ArrangementSubnet Mask Pinging for the IP AddressPinging to determine the Extron IP address Class Name Subnet MaskConnecting as a Telnet Client Pinging to determine the web IP addressConnecting to the AVT Open command Telnet tipsSubnetting a Primer GatewaysLocal and remote devices IP addresses and octetsSubnet masks and octets Determining whether devices are on the same subnetUnmasked octets are compared indicated by ? in figure Masked octets are not compared indicated by X in figureFrequency Tables Atsc Frequency TablePhysical Lower Edge Video Audio Upper Edge ChannelAtsc Frequency Table Cable Frequency Table HRC CablePhysical Channel Visual Carrier Frequency MHz Cable Frequency Table Cable Frequency Table USA, Canada, South America Japan Central America Europe, Africa, and the Middle China EastAsia Middle East Europe