Extron electronic manual Buttons on the AVT 200HD Remote Control

Page 40

Buttons on the AVT 200HD Remote Control

The following functions are available through the buttons on the AVT 200HD IR Remote Control:

1

14

13

12

11

10

9

MUTE

VIDEOAUDIO

CHANNEL TUNE VOLUME

PRESET

CHANNEL SEL ECTION

1 2 3 CC

4 5 6

7 8 9 SAVE

0ENTER

LAS T

SHIFT

INFO

GUIDE

FREEZE

2

3

4

5

6

7

8

AVT 200HD Remote

Figure 29. Buttons on the AVT 200 Remote Control

AVideo and Audio Mute buttons — Toggle video and audio output muting on and off.

When the channel is changed, the video is unmuted.

When the volume is adjusted, the audio is unmuted.

BPreset — Puts the AVT in preset mode. In preset mode, the Channel Selection buttons

(B) switch between preset channels.

CVolume — Press the top (up arrow) or bottom (down arrow) section of this rocker button to raise or lower the output volume.

DCC — Selects a closed captioning service (CC1 through CC6) or turns it off.

ESave — In tune mode, saves the currently selected channel as a preset. (Presets cannot be saved while the AVT is in preset mode.)

FEnter — After using the numbered selection buttons (L) to select a channel or preset number, press this button to switch to that channel or preset.

GShift buttons — After the Guide button (I) is pressed:

The up and down arrow buttons step through the program menu on the on- screen display.

The left arrow button lets you back-space and delete numbers that you entered

on the LED panel by pressing the channel selection buttons (L). This button does not delete numbers after you press the Enter button to confirm your selections.

The right arrow button is reserved for future use.

HFreeze — Freezes and unfreezes the video output.

AVT 200HD Tuner • Operation

34

Image 40
Contents AVT 200HD Safety Instructions English FCC Class a Notice Conventions Used in this Guide Contents Html Configuration About this Guide FeaturesAbout the AVT 200HD Tuner AVT 200HD Tuner Introduction Application Diagram Application Diagram for the AVT 200HDInstallation Installation OverviewVideo Output Connectors Rear Panel FeaturesComposite and S-video stacked video output connectors Audio Output Connectors Analog audio output connectorsRemote Configuration and Control Connectors Input ConnectorDigital audio output connectors Control Connections Wiring for RS-232 ControlEthernet Connection Wiring for IR Control Wiring the IR LinkConnecting to the USB Port Connecting the AVT 200HD to the IR LinkFound New Hardware Wizard Opening Screen AVT 200HD Tuner Installation Front Panel Features AVT 200HD Front PanelHdcp Compliance NBC-4LAPowering On Power-up and Default Cycle Screens ExampleMenus on the LCD Screen Using the menusMenu System Overview Menu flow diagram AVT 200HD Menu FlowChannel Setup Menu Selecting the signal sourceScanning for channels Option Scans forScanning Channels with long minor numbers CableOutput Configuration Menu Selecting tune or preset modeSaving presets Not available via the front panel Selecting a channelRecalling presets Selecting the output resolution and refresh rateSelecting the display mode Resolution CompositeSelecting the display aspect ratio Simultaneous Video OutputAudio Configuration Menu Selecting the closed caption serviceComm Setting Menus Comm Setting Menu FlowViewing serial port and IP settings Configuring the serial port and IP parametersUnit Reset Menu Resetting from the Front Panel Unit Reset Menu FlowResetting from the Rear Panel Volume ControlExiting the Menu System Reset Modes Summary Activation Result Purpose/Notes Exec Mode Select Disable Locking and Unlocking the Front Panel Executive ModesUsing the AVT 200HD IR Remote Control Executive Mode Menu FlowInstalling batteries in the AVT 100 Remote Area for Remote Signal ReceptionButtons on the AVT 200HD Remote Control Buttons on the AVT 200 Remote ControlSelecting a Channel or Preset Using the IR Remote Control Channel Selection buttons 0 throughLocking IR Remote Control Access Using the On-screen Display OSDIntroductory Display Volume Level Display Channel Information DisplayProgram Guide Serial Port USB PortEthernet Port Ethernet CableIP Address Connection TimeoutsEstablishing an Ethernet Connection Using SIS Commands Tuner-initiated MessagesChip Security for Parental Control Copyright message With an RS-232 connectionError Response References Tuner Error ResponsesUsing the Command/Response Tables for SIS Commands Symbol Definitions for AVT 200HD Specific Commands Special CharactersX1@ X1#X2@ X2# X2% X3@ X3#Command/Response Table for AVT 200HD SIS Commands EX!*X@TVSLX!*X@TVCH EX!*X@TVCHX2%TVPR EX2RATE EX2%NGEX2&OPOL EX1TVOS EX1TVTMEX1TVPG X1 Tvcc X1% FsccX1% X1 FsccX1&FSCC X1*FSCCX2*FSCC ExafmtChip Setup Parental Control EX* LangX1$ VolX1$ X3@Chip Setup X3@*X1VCHPX3@*X2@VCHP X2@$ Tvst Other SettingsTvst ‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘ Executive Mode Front Panel Lockout Information RequestsResets EZIX4# Symbol Definitions for IP-specific CommandsX5# X5$ X6# X6$X7# X7$X8# X8$EX4!CP Command/Response Table for IP-Specific SIS CommandsEX!CE EX5@CN ECNEX5#CT ECTEDH EX5$CIECI ECHBmdX9% ,X5$ EX4@ *X10# *X10$ PB BptX4@ *X5EX7$ ,X5$ ID EdiX7$ *X5$ *X4@ X7$ = 0EX4@MH EMHEX4@MD EMDEX7$ ,X7% ,X7 ,X7& E EX7$ ,X7% ,X7 ,X7*X7& E EvtX7$ ,X7% ,X7 ,X7EvtX7$,X7%,X7, string EX7$ ,X7% ,X7 ,X8 FEDownloading and Installing the Software from the Web Accessing the AVT 200HD Configuration & Control SoftwareComputer System Requirements Installing the Software from the Disc Software Button on the DVD Opening ScreenCommunication Setup Window with Telnet Tab Starting the SoftwareRS232 Connection Tab Setup Tab on the Main Window Using the Configuration & Control Program Help File Updating the FirmwareExtron Firmware Loader Window for AVT 200HD Firmware Update in Progress Accessing the Web Pages HtmlExample of a Network Password Dialog Box Special CharactersSystem Status System StatusConfiguration Pages System SettingsIP Settings Fields Unit Name fieldDate/Time Settings Fields Date/Time Settings FieldsTuner Settings Tuner SettingsEdit Channels and Presets section Channel Scan sectionTo hide a channel To show a hidden channelOutput Setup section Executive ModeSetting a password PasswordsRemoving passwords Firmware Upgrade Firmware UpgradeChoose File Window with a Firmware File Selected File Management Uploading FilesAdding a Directory Other File Management ActivitiesControl Pages User ControlAdjusting the volume Selecting a presetKeypad Closed Captioning Closed CaptioningChip Text Size Text Style Text Fill Text ColorMovie Rating Parental Control section Chip ScreenTV Rating Parental Control section Maximum Allowed TV Rating for Ages sectionChange PIN section Specifications Signal processingRF video input Video output analogVideo output digital SyncAudio output analog Audio output digitalPower VAC to 240 VAC, 50-60 Hz, 25 watts, internal GeneralPart Numbers and Accessories Optional AccessoriesIncluded Parts CablesMounting the Tuner Rack Mounting ProcedureUL Guidelines for Rack Mounting What is an IP Address? IP AddressingChoosing IP Addresses Class Name Valid Address Range Identifier ArrangementSubnet Mask Pinging for the IP AddressPinging to determine the Extron IP address Class Name Subnet MaskConnecting as a Telnet Client Pinging to determine the web IP addressConnecting to the AVT Open command Telnet tipsSubnetting a Primer GatewaysLocal and remote devices IP addresses and octetsSubnet masks and octets Determining whether devices are on the same subnetUnmasked octets are compared indicated by ? in figure Masked octets are not compared indicated by X in figureFrequency Tables Atsc Frequency TablePhysical Lower Edge Video Audio Upper Edge ChannelAtsc Frequency Table Cable Frequency Table HRC CablePhysical Channel Visual Carrier Frequency MHz Cable Frequency Table Cable Frequency Table USA, Canada, South America Japan Central America Europe, Africa, and the Middle China EastAsia Middle East Europe