Toshiba SD-V280 manual Battery precautions, Operation

Inserting Batteries

Open the battery compartment	Install two "AAA" batteries	3	Replace the compartment
cover in the direction of the	(supplied), paying attention to the		cover.
1 arrow.	2 polarity diagram in the battery

compartment.

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Remote control basics

•Press POWER ( ) to turn the DVD/VCR on or off.

•Select your desired operating mode (DVD or VCR) using DVD/VCR.

(DVD or VCR indicator on the front panel will show you which mode is selected.)

•Press CH or CH to move through the channels one channel at a time.

•The CH / ( / ) and SET +/–( / ) are also used to navigate on-screen menu system.

•You can directly access specific channels using Number buttons.

•Each press of DVD/VCR on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote	Approx. 7 meters
sensor, up to a distance of Approx. 7 meters.

Introduction

13