Toshiba SD-V280 manual Setting the video channel, Basic setup, For a push-button TV tuner

Basic setup

Setting the video channel

When a TV is connected with the 75 ohm coaxial cable only.

To view playback of a recorded tape or DVD disc, or to watch a program selected by the VCR's channel selector, the TV must be set to channel 3 or 4 (video channel).

DVD/VCR POWER

TV/VCR

Setting the video channel

1 Press POWER to turn on the DVD/VCR.

2 Press DVD/VCR to select the VCR mode.

The VCR indicator on the front panel will light.

3 Set the 3/4 Channel selector switch on the rear panel to CH 3 or 4.

3 4 CH

4 Turn ON the TV and set to CH 3 or 4 to corre- spond with the channel selected in step 3.

5 Press TV/VCR to select the VCR position.

The VCR indicator will appear in the display window.

6 Select any channel to receive a TV station in your area. The channel number will appear on the screen for about 4 seconds.

For a push-button TV tuner

If CH 3 or 4 corresponding to the video channel cannot be tuned on your TV, proceed as follows: set the VCR 3/4 channel selector and the TV to CH 3 or 4, play back a prerecorded tape and tune the TV to receive a sharp color picture from the video cassette recorder. Refer to your TV owner's manual for details.

Notes:

•If the unit does not operate properly, or No key op- eration (by the unit and/or the remote control): Static electricity, etc., may affect the player's operation. Discon- nect the AC power cord once, then connect it again.

•When you turn on the DVD/VCR which has disc inside, DVD playback will start automatically.

If the operating mode was VCR, when you turned on the DVD/VCR which has disc inside, it will play back auto- matically and stop after about 5 minutes.

•During the DVD playback if you change the operating mode from DVD to VCR, the DVD will continue to play back the disc and stop after about 5 minutes.

22