Toshiba SD-V280 manual Lightning, Heat

Page 4

Introduction

IMPORTANT SAFEGUARDS

13.LIGHTNING

To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

18.SERVICING

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE

Unplug this unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled, or objects have fallen into the unit.

c.If the unit has been exposed to rain or water.

d.If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

e.If the unit has been dropped or the cabinet has been damaged.

f . When the unit exhibits a distinct change in performance, this indicates a need for service.

20. REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock or other hazards.

21. SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

22. HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

23. DISC TRAY

Keep your fingers well clear of the disc tray as it is closing. It may cause serious personal injury.

24. CONNECTING

4

When you connect the product to other equipment, turn off the power and unplug all of the equipment from the wall outlet. Failure to do so may cause an electric shock and serious personal injury. Read the owner's manual of the other equipment carefully and follow the instructions when making any connections.

Image 4
Contents SD-V280 Introduction Location of the required MarkingS3125A IntroductionLightning HeatDisc Precautions Do not use the DVD/VCR when moisture condensation may occurTo obtain a clear picture Moisture condensation occurs during the following casesOn cleaning discs On handling discs Structure of disc contentsOn storing discs On Video CDs Playable discsDVD VideoContents Front panel Identification of ControlsRear panel Display window VCR operation StatusDVD operation Status While watching TV While operating a tapeRemote control Menu buttonBattery precautions OperationAntenna connections Antenna to DVD/VCR connectionConnections DVD/VCRConnections Set the TV/CATV menu option to TV mode Set the TV/CATV menu option to TV modeDVD/VCR to TV connection TV with single 75 ohm VHF/UHF antenna inputCatv Cable TV connections DVD/VCRSwitch SplitterIncoming Cable Converter/Descrambler ConnectionsConnecting to a TV Connecting to a TVOUT Video Component video ColorStream outputs/inputsConnecting to optional equipment Connecting to an amplifier equipped with a DTS decoderConnect either Make the following setting MPEG2 soundSetting the video channel Setting the video channelBasic setup For a push-button TV tunerSetting the language Setting the languageClock setting To set auto clock to offTo set standard time To set daylight saving time Press SET + or to select System SETUP, then press Enter Press SET + or -to select ST Andard Time , then Press EnterManual clock setting Press SET + or to select Clock SET, then press EnterPress SET + or to set the month, then press EnterSetting channels automatically Tuner settingTV/CATV selection To ADD/DELETE channels Noise eliminationLoading and unloading a cassette tape LoadingUnloading To prevent accidental erasurePlayback Cassette tape playbackRewind or forward the tape Special playback Press Counter Reset at the desired tape position Convenience functionRepeat playback Zero return function RepeatClock/counter display Video index search system Sqpb S-VHS Quasi PlaybackCounter ClockRecording a TV program Recording a TV programRecording VCR VHF/UHF/CATV Channels CatvTo stop recording temporarily To stop recordingRecording one program while watching another One-touch Timer Recording OTR One-touch Timer Recording OTRTo cancel OTR Set TV or CA TV option to the appropriate positionTimer recording Timer recordingPress VCR MENU. Select Timer REC SET, then press Enter To enter other programs, repeat throughTo confirm or cancel a program To confirm Timer programTo cancel Timer program If the programs overlap anotherStereo recording and playback Separate Audio Program SAPStereo recording and playback Separate Audio Program SAP Other functions VCRDuplicating a video tape Duplicating a video tapeConnection with second video recorder Recording a DVD/CD disc Duplicating a DVD or CD discPress Play to start playback Press REC to start recording Disc is Copy ProtectedTo start playback in the stop mode Playing a discBasic playback Basic playback DVDTo pause playback still mode To obtain a higher quality pictureTo stop playback To remove the discPlaying in fast reverse or fast forward directions Vcddvd Playing frame by frameTo resume normal playback Press REW or FWD during playback Press PlayVCD Resuming playback from the same location Vcddvd Playing in slow-motionPress Slow during playback DVD Locating a title using the top menu Locating a specific title, chapter, or trackLocating a specific chapter or track Press TOP MenuRepeat playback / Random playback Repeat playback and Random playbackVcdcd Repeating a specific segment Advanced playback DVDVCD Setting titles, chapters, or tracks in a favorite order Playing in a favorite orderZooming a picture DVD Zooming a pictureYou can magnify areas within a picture Press Zoom during normal, slow or still playbackCancel Selecting the camera angleChanging the camera angle To turn off the angle number displayCurrent subtitle setting is displayed Selecting subtitlesDVD Selecting a subtitle language To turn subtitles on or offVcddvd Selecting a playback audio setting Current audio setting is displayedSelecting a language Selecting sound channels of Video CDsVCD Selecting the sound enhancement To exit the audio enhancement selectionPress / to select the E.A.M icon, then Sound enhancement menu appearsOn-screen display operation VCD On-screen display operationPress Display Press Display againOFF CDs. Some characters may not be displayedProperly depending on the disc On-screen display turns offPress SET UP To return to the previous displayAppears On-screen display disappearsPBC Customizing the function settings Setting detailsFunction setup DVD PCMKaraoke Vocal DVD Press the Enter buttonAudio Language DVD More clearer when you pause it Function are rated according to their content.Blue Blue background Gray Gray background So that you can make a motionless pictureFollow steps 1 To change the parental lock levelTo change your 4-digit security code Title Stop DVD Video CDTable of languages Table of languages and their abbreviationsOthers Abbreviation LanguageSymptoms and correction Before calling service personnelOthers Specifications General / input / output / supplied accessoriesSupplied accessories Input/OutputLimited Ninety 90 Day Warranty Limited One 1 Year WarrantyRental Units Commercial UnitsHow to Obtain Warranty Service Important Packing and Shipping InstructionQuick set-up guide Important Safeguards SET UP menu screen in may Will lightIf you use the unit for the first time Press VCR MENU, instead of the mainAuto clock setting Screen for about 4 seconds Timer recording Basic playback DVD Fast Forward PlaybackReview Playback Still PlaybackLocating a chapter or track Remote control basicsInserting Batteries