Toshiba SD-V393SU To wall outlet If you connect the DVD/VCR to, Your TV with the DVD OUT jacks

S-video output

An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television has S- Video input, and does not have component video inputs.

Component video outputs

PROGRESSIVE outputs

Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker.

INTERLACED outputs

Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality DVD picture playback.

Notes:

•Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)

•In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV or monitor for optimum performance.

Connecting to an audio system and TV equipped with S-video input/component video inputs

The S-video output and component video output transports the DVD-video signal exclusively and will deliver enhanced DVD video picture performance.

Signal flow

			To ANALOG
			AUDIO OUT
			(white)
			(red)
To wall outlet				If you connect the DVD/VCR to
To S-	To PR/CR	To PB/CB	To Y
				your TV with the DVD OUT jacks,
VIDEO	VIDEO	VIDEO	VIDEO	select the corresponding video
OUT	OUT	OUT	OUT	input on your television to watch
			Component	DVD video discs.
			video cable
			(not supplied)	Audio cable (not supplied)
				To audio inputs of
				the amplifier
			To Y video input		(red) (white)
		To PB/CB video input
	To PR/CR video input
	To S-video input
S-video cable (not supplied)					Audio system
			TV or monitor with

To switch the scan mode between the	ColorStream®
	component video inputs
interlace and progressive modes, see
page 59.

Connections

Notes:

•Refer to the owner’s manual of the connected equipment as well.

•When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD/ VCR away from the tuner and radio.

•The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the amplifier before you connect or disconnect the DVD/VCR’s power cord. If you leave the amplifier power on, the speakers may be damaged.

•When connecting to a TV using the Video or S-video jack, make sure that the Progressive indicator “” on the display window is not lit. If it is lit, the Video and S-video outputs do not feed the correct signals and you cannot see any picture. To turn off the Progressive indicator, select PROGRESSIVE scan Off ￿￿.

19

2H20101A (E)p18-25 19 2/10/05, 7:32 PM