Toshiba SD-V393SU manual Setting the video channel, Basic setup, For a push-button TV tuner

OR

The video channel will start to flash for 3 seconds in the display window.

2 Press POWER to turn on the DVD/VCR.

3 Press VCR DVD selector to select the VCR mode.

The VCR indicator on the

front panel will light.

4 Turn ON the TV and set to CH 3 or 4 to corre- spond with the channel selected in step 1.

5 Press TV/VCR to select the VCR position.

The VCR indicator will appear in the display window.

Select any channel to receive a TV station in your area. The channel number will appear on the screen for about 4 seconds.

Basic setup

Setting the video channel

When a TV is connected with the 75 ohm coaxial cable only.

To view playback of a recorded tape or DVD disc, or to watch a program selected by the VCR's channel selector, the TV must be set to channel 3 or 4 (video channel).

POWER VCR DVD

TV/VCR

3

4

Setting the video channel

1Press and hold 3 or 4 on the remote for 3 seconds in standby mode.

For a push-button TV tuner

If CH 3 or 4 corresponding to the video channel cannot be tuned on your TV, proceed as follows: set the VCR 3/4 channel selector and the TV to CH 3 or 4, play back a prerecorded tape and tune the TV to receive a sharp color picture from the video cassette recorder. Refer to your TV owner's manual for details.

Note:

If the unit does not operate properly, or No key operation (by the unit and/or the remote control): Static electricity, etc.,

may affect the player's operation. Disconnect the AC power cord once, then connect it again.

6

22

2H20101A (E)p18-25 22 2/10/05, 7:32 PM