Pioneer Troubleshooting Guide for HDMI and i.LINK Issues in DVD Players

09Additional information

ProblemRemedy

A connected HDMI component doesn’t work with this player.

•Depending on the connected component, this player may not work properly with it. See the operating instructions that came with the other component.

i.LINK troubleshooting

(DV-868AVi only)

Problem	Remedy
No i.LINK audio output.	• If the front panel i.LINK indicator is lit then:
	– Check that your AV receiver is DTCP (Digital Transmission Copy
	Protection) compatible.
	– Check that your AV receiver is compatible with the type of disc that
	you’re trying to play (for example, SACD).
	• If the front panel i.LINK indicator is unlit then:
	– Check that your AV receiver is set to the correct input.
	– Check that the i.LINK cable is connected properly and that the cable
	isn’t damaged. Use an i.LINK cable no longer than 3.5 meters.
	– Check that components connected using the i.LINK interface are
	switched on and i.LINK Audio compatible. Do not connect DV format
	players/recorders or personal computers.
	– Check that the i.LINK Audio Out setting is On (see Audio Out on
	page 76).
	– Check that the PURE AUDIO indicator is not lit. If it is, press the
	PURE AUDIO button (See also Front panel on page 24).

Auto Select Play doesn’t work.

•Make sure that the receiver has been selected in the Auto Select Play on page 77.

•Make sure that i.LINK Audio Out is set to On (see Audio Out on page 76).

•Auto Select Play doesn’t work while LINK CHECK shows in the front panel display (see i.LINK-related messages opposite).

i.LINK audio is temporarily	• See i.LINK-related messages for possible causes of this.
interrupted.
No multichannel i.LINK	• For multichannel SACD playback, make sure that SACD Playback is
audio.	set to Multi-ch Area (see SACD Playback on page 71).
	• For multichannel DVD-Audio playback, make sure that Audio
	Output Mode is set to 5.1 Channel (see Audio Output Mode on
	page 73).

94

En