Pioneer DV-667A-S, DV-563A, DV-667A-K operating instructions Connecting up Easy connections

02Connecting up

Easy connections

The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In this setup, stereo audio is played through the speakers in your TV.

							A/V IN
		TV
			Y	PB	AUDIO OUT(2CH)
		DIGITAL			L	L	CENTER
CONTROL			COAXIAL
		AUDIO OUT
IN	OUT						AUDIO OUT
							(5.1CH)

	S		PR	R	R	SUB
OPTICAL		VIDEO OUT			FRONT SURROND	WOOFER
			COMPONENT VIDEO OUT

To power outlet

•This player is equipped with copy protec- tion technology. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. (This player may also not be compatible with some combination TV/VCRs for the same reason; refer to the manufacturer for more information.)

•When connecting to your TV as shown above, do not set the Component Out setting (page 56) to Progressive.

1Connect the VIDEO OUT and AUDIO OUT (2ch) jacks to a set of A/V inputs on your TV.

Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound.

See below if you want to use an S-video, component or a D video connection.

•If you need another pair of stereo outputs (and don’t need to use the multichannel analog outputs), you can use the AUDIO OUT (5.1ch) FRONT L / R jacks

(page 17).

2Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet.

14

En