Pioneer DV-563A, DV-667A-K, DV-667A-S Connecting up, Using other types of video output

Connecting up

•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel

STANDBY/ON button, or the remote control, and wait of the -OFF-message to disappear from the player’s display.

•For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers.

•When Component Out (page 56) is set to Progressive, there is no video output from the VIDEO OUT (composite) and S (S-video) jacks. If you want to display video on more than one monitor simulta- neously, make sure that it is set to Inter- lace. Switch the player to standby then, using the front panel controls, press

STANDBY/ON while pressing

to switch the player back to Interlace.

Using other types of video output

This player has standard (composite), S-Video and component video outputs (the DV-667A (Taiwan model) has a D video connector for component video). The main difference between them is the quality of the picture.

S-Video delivers a better picture than stan- dard composite video, while component video gives better picture quality still. The variety of outputs also gives you the flexibility of connecting your particular equipment using the best connection type available.

02

Connecting using the S-video output

If your TV (or other equipment) has an S-video input, you can use this instead of the stan- dard (composite) output for a better quality picture.

•Use an S-video cable (not supplied) to connect the S-VIDEO OUT to an S-video input on your TV (or monitor or AV receiver).

Line up the small triangle above the jack with the same mark on the plug before plugging in.

S-VIDEO

IN

TV

Y	PB	AUDIO OUT(2CH)
		L	L	CENTER
DIGITAL COAXIAL
AUDIO OUT

AUDIO OUT

(5.1CH)

	S		PR	R	R	SUB
OPTICAL		VIDEO OUT			FRONT SURROND	WOOFER
			COMPONENT VIDEO OUT

15

En