Aiwa XD-DV370 operating instructions Connections, TV System Select switch

CONNECTIONS

At first, decide the outline of the connection among this unit, your TV set and the amplifier, etc. It is necessary to set the setup menu of this unit according to the connection.

Before connection, identify the type of your audio equipment or of the TV set referring to the following chart. Then decide the connection and the setup menu according to the types.

Audio system to be connected	Input jack of equipment to be	Referring
	connected to the DVD player	Letter
None (only the television is connected)		See A.
A stereo system or an amplifier	Digital input jack	See B.
	Analog audio input jacks (L/R)	See C.
An AV amplifier equipped with Dolby Digital	Digital input jack	See D.
decoder or a Dolby Digital decoder
	Analog audio input jacks (L/R)	See F.
An AV amplifier equipped with DTS decoder	Digital input jack	See E.
or a DTS decoder

Before making connections

•Connect the AC cords of the unit and external equipment at the end, after finishing the other connections.

•Insert the plugs completely into the jacks. Loose connections may produce a humming sound or other noise interference.

•When using an optical connection, remove the dust cap from the DIGITAL OUT (OPTICAL) jack on the rear of this unit. Keep the cap in store. When not using optical connections, the dust cap should be in place.

•Refer to the instructions for the connected equipment.

TV SYSTEM SELECT switch

This switch enables you to make use of a TV set which is NTSC or Multi colour system. The default setting is “PAL”.

	DIGITAL OUT	AUDIO
		OUT
DIGITAL	COAXIAL
	S-VIDEO
OUT
		NTSC
		PAL AUTO
OPTICAL	OUT	VIDEO
		OUT

NTSC

PAL AUTO

CAUTION

Do not select “DOLBY DIGITAL/PCM or Stream/PCM” in the “Digital Audio Output” when connecting to an AV amplifier not equipped with a Dolby Digital decoder or DTS decoder (with an optical or coaxial connecting cord). Merely attempting to play a DVD may cause a high level of noise which could be harmful to your ears and damage the speakers. In such a case, be sure to select “PCM” in the “Digital Audio Output”.

Before turning on the unit;

•Set to “PAL”, when connecting to the TV set of PAL colour system.

•Set to “AUTO”, when connecting to the TV set of Multi colour system.

•Set to “NTSC”, when connecting to the TV set of NTSC colour system.

NOTES

•When the picture noise appears while copy-protected DVDs are played, connect the unit directly to a TV set. Do not connect through a VCR, TV/VCR or AV selector.

•For the speakers and their connection, refer to the instructions for the AV amplifier.

NOTE

The unit cannot playback DVDs and video CDs that are recorded in the PAL colour system, if “NTSC” is set.

10