Aiwa XD-DV370 operating instructions Connecting to an AV amplifier equipped with a DTS decoder

E Connecting to an AV amplifier equipped with a DTS decoder

Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with a Digital In jack. The supplied video cord is also available instead of the coaxial cord.

TV set

to 21 pin scart connector

21 pin scart cable (not supplied)

to 21 pin scart connector

Rear of the unit

	DIGITAL OUT	AUDIO
		OUT
	COAXIAL	L
DIGITAL
	S-VIDEO
OUT
		R
		NTSC
		PAL AUTO
OPTICAL	OUT	VIDEO
		OUT

PREPARATIONS

to DIGITAL OUT OPTICAL jack

Optical cord (not supplied)

to a digital input jack

to DIGITAL OUT COAXIAL jack

or Coaxial cord

(not supplied)to an AC power socket (AC 230 V, 50 Hz)

Amplifier equipped with a

DTS decorder

Front			Front speaker (R)
speaker (L)
Surround speaker (L)	Centre speaker	Subwoofer	Surround speaker (R)

When your TV set is equipped with an S-video input terminal, see page 17.

Set the setup menu correctly after connecting!

According to the audio equipment and TV set to which the unit is connected, set the “Digital Audio Output” and “TV Aspect” of the setup menu correctly referring to the following below.

See “CHANGING SETUP VALUE” on page 39 in detail.

Digital Audio Output

Stream/PCM

TV Aspect

When your TV set is a conventional-screen size TV: 4:3 Letter box

When your TV set is a wide-screen size TV: 16:9 Wide

NOTE

When the picture noise appears while copy-protected DVDs are played, connect the unit directly to a TV set. Do not connect through a VCR, TV/VCR or AV selector.

CAUTION

If the AV amplifier is not equipped with a DTS decoder, do not select “Stream/PCM” in the “Digital Audio Output” when connecting the AV amplifier with an optical or coaxial connecting cord.

Merely attempting to play a DVD may cause a high level of noise which could be harmful to your ears and damage the speakers.In such a case, be sure to select “PCM” in the “Digital Audio Output”.

15