IMPORTANT SAFETY
INSTRUCTIONS
Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.
Installation
1Water and moisture — Do not use this unit near water, such as near a bathtub, sink, swimming pool, or the like.
2Heat — Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. This unit should not be placed in temperatures less than 5˚C (41˚F) or greater than 35˚C (95˚F).
3Mounting place — Place the unit:
-on a flat , even surface
-away from strong magnetic fields
-at least one metre away from any radios or receivers Do not place heavy objects on the unit.
4Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow a clearance of 10 cm (4 in.) from the rear and the top of the unit, and 5 cm (2 in.) from each side.
-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.
-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.
-To avoid internal heat
5Foreign objects and liquid — Be careful that foreign objects or liquid do not enter the unit through the ventilation openings.
6Carts and stands — The unit should be moved with care when placed or mounted on a stand or cart. Sudden stops, excessive force, or an uneven surface may cause the unit or cart to fall over.
7Condensation — Moisture may form on the pickup lens when:
-This unit is moved from a cold spot to a warm spot
-A heating system has just been turned on
-The unit is used in a very humid room
-The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.
Electric power
1Power sources — Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.
2AC power cord
-When disconnecting the mains lead, pull it out by the mains plug. Do not pull the mains lead itself.
-Never handle the mains plug with wet hands, as this could result in fire or electrical shock.
-Mains lead should be firmly secured to avoid being severely bent, pinched, or walked upon. Pay particular attention to the mains lead from the unit to the mains.
-Avoid overloading mains plugs and extension leads beyond their capacity, as this could result in fire or electrical shock.
3When not in use — Unplug the mains lead from the mains if the unit will not be used for several months or more. When the mains lead is plugged in, a small electrical current continues to flow into the unit, even if the power is turned off.
4In case of lightning — Immediately disconnect the mains lead from the mains.
Maintenance
Clean the unit only as recommended in the Operating Instructions.
Damage requiring service
Have this unit serviced by a qualified service technician if:
-The mains lead or plug has been damaged
-A foreign object or liquid has entered the unit
-The unit has been exposed to rain or water
-The unit does not seem to operate normally
-The unit exhibits a marked change in performance
-The unit has been dropped, or the cabinet has been damaged
DO NOT OPEN THE CABINET AND ATTEMPT TO SERVICE THE UNIT YOURSELF.
INTRODUCTION
3