Samsung DVD-V4500 instruction manual PCM Down Sampling TV Aspect Ratio, Dynamic Compression

DTS Dynamic Compression

PCM Down Sampling TV Aspect Ratio

If your A/V receiver is equipped with a DTS decoder, your DVD-VCR can output DTS digital sound, but you MUST enable this feature in the menu system.

NOTE: Select “On” ONLY if you have connected a DTS-equipped A/V receiver to the Digital audio Out (coaxial) on the DVD-VCR rear panel.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “DTS”

Highlight “DTS” then press the RIGHT button to select one of the following options:

•Off – To use your DVD/TV with an A/V receiver NOT equipped with a DTS decoder.

•On – To use your DVD/TV with an A/V receiver equipped with a DTS decoder

Off

On

PCM Down Sampling : On

Dynamic Compression restrains the dynamic range of sounds, i.e. the difference between the loud and quiet passages of a DVD audio track.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “Dynamic Compression”

Highlight “Dynamic Compression”, then press the RIGHT button to select one of the following options:

•On – This will compress the total dynamic range of the DVD audio, making quiet passages in the audio signal louder and loud passages softer.

•Off – This will preserve the original dynamic range.

	On	On
	On
		Off
PCM Down Sampling	: Offn

If your amplifier is not capable of reproducing a 96kHz signal, PCM downsampling should be set to on.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD ” then press the ENTER button.

3Select “Audio”

Highlight “Audio”, then press the ENTER button.

4Set “PCM Down Sampling”

Highlight “PCM Down Sampling”, then press the RIGHT button to select one of the following options:

•On – When a 96K audio disc is played, 96K will be downsampled to 48K and outputted.

•Off – When a 96K disc is played, 96K will be outputted.

PCM Down Sampling	: On	On
		Off

Set the aspect ratio (length x width) of your TV screen so the DVD player will display movies at the appropriate size for your television. Choose from standard, letterbox, or widescreen format.

1Open “MENU”

Press the MENU button while the DVD is in Stop mode.

2Select “DVD”

Use the UP/DOWN buttons to highlight “DVD” then press the ENTER button.

3Select “Display”

Highlight “Display”, then press the ENTER button.

4Set “TV Aspect”

Highlight “TV Aspect” then press the RIGHT button to select one of the following options:

•Widescreen - This method allows you to view the full 16:9 picture on a widescreen television.

•Letterbox - This method displays the full width of the widescreen movie on a standard 4:3 television. As a result, black bars will appear at the top and bottom of the screen.

•Pan-Scan - The familiar way of watching DVD and VHS movies, this method selectively crops (by panning and scanning to keep the most important part of the picture visible) wide screen movies to fit a standard 4:3 television screen.

Display Setup

ENG-16 ENG-17