Toshiba 51HX94 owner manual Care

Page 4

24)Always operate this equipment from a 120 VAC, 60 Hz power source only.

25)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

26)DANGER: RISK OF SERIOUS PERSONAL

INJURY OR DEATH!

• Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity:

a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

27)Always sit approximately 10–25 feet away from the TV and as directly in front of it as possible. The picture can appear dull if you sit too far to the left or right of the TV, or if sunlight or room lights reflect on the screen. Turn the TV off to check for reflections on the screen, and then remove the source of reflections while viewing the TV.

28)Always unplug the TV before cleaning. Never use liquid or aerosol cleaners. Alwayas clean the screen and cabinet with dry cloth only. Clean the cabinet back so dust does not clog the slots or fan. Never spray volatile

compounds (such as insecticide) on the cabinet, which may cause cabinet discoloration or damage.

29)WARNING: RISK OF ELECTRIC SHOCK!

Never spill liquids or push objects of any kind into the TV cabinet slots.

4

30)If the air temperature rises suddenly (for example, when the TV is first delivered), condensation may form on the lenses. This can make the picture appear distorted or the color appear faded. If this happens, turn off the TV for 6 to 7 hours to allow the condensation to evaporate.

31)For added protection of your TV from lightning and power surges, always unplug the power cord and disconnect the antenna from the TV if you leave the TV unattended or unused for long periods of time.

32)During normal use, the TV may make occasional snapping or popping sounds. This is normal, especially when the unit is being turned on or off. If these sounds become frequent or continuous, unplug the power cord

and contact a Toshiba Authorized Service Center.

33)Possible Adverse Effects on TV Picture Tube: If a fixed (non-moving) pattern remains on the TV screen for long periods of time, the image can become permanently engrained in the picture tube and cause subtle but permanent ghost images. This type of damage is NOT COVERED BY YOUR WARRANTY. Never leave your TV on for long periods of time while it is displaying the following formats or images:

Fixed Images, such as PIP/POP windows, stock tickers, video game patterns, TV station logos, closed captions, and websites.

Special Formats that do not use the entire screen. For example, viewing letterbox style (16:9) media on a normal (4:3) display (gray bars at top and bottom of screen); or viewing normal style (4:3) media on a widescreen (16:9) display (gray bars on left and right sides of screen).

Service

34)WARNING: RISK OF ELECTRIC

SHOCK! Never attempt to service the TV yourself.

Opening and removing the covers may expose you to dangerous voltage

or other hazards. Refer all servicing to a

QUALIFIED

SERVICE

Toshiba Authorized Service Center.

TECHNICIAN

 

35)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Remove the CableCARD™ and/or memory card (if applicable) before servicing.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

Note: Toshiba is not responsible for loss of data as a result of servicing. After the TV is serviced, you may need to repeat the setup process for applicable features.

36)When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. Improper disposal may result in a picture tube implosion and possible personal injury.

51,57HX94(E)002-04

4

9/12/04, 6:56 PM

Image 4
Contents 51HX94 57HX94 Safety Precautions It Makes a Difference Where Your TV StandsIssue Tune Into SafetyInstallation, Care, and Service Important Safety InstructionsAlways place the TV on the floor Care Contents 102 Introduction Features of your new TVWelcome to Toshiba Introduction Connecting your TV Power Ñ Press to turn the TV on and offTV front panel controls and connections 6 7 8TV back panel connections For an explanation of cable types, seeOverview of cable types To a Personal Computer PCConnecting a digital CableCARD About the connection illustrationsFor more information, call your local Cable operator You will needConnecting a VCR and antenna or Cable TV no Cable box Connecting a camcorderTo use the TV Guide On Screen recording features To view the VCROn Screen recording features Connecting a VCR and Cable boxTo view basic and premium Cable channels To view satellite programs using the standard Connecting a VCR and satellite receiverVideo connections or to record satellite programs To view the DVD player To view premium Cable channelsTo view VCR To view antenna or Cable channels Two coaxial cablesTo record a TV program while watching a DVD Connecting two VCRs Connecting an Hdmi or a DVI device to the Hdmi input ¥ one Hdmi cable type a connector for each deviceTo connect Hdmi devices, you will need To connect DVI devices, you will needConnecting a digital audio system Connecting an analog audio systemOne optical audio cable To control the audioIEEE-1394 devices using On-screen control icons TheaterNet on-screen device controlTo connect the IR blaster cable To control the devicesConnecting IEEE-1394 video devices Supported signalsWhen you connect a D-VHS or A/V HD device to the TV IEEE-1394 device initializationIEEE-1394 device management To edit the IEEE-1394 device informationTo connect to the G-LINK jack LINKconnectionSee Chapter Using the remote control Learning about the remote controlTo install the remote control batteries Installing the remote control batteriesDevice mode control after programming Remote Control functional key chart PowerAudio VCR Mute Device code setup Press Mode to select the TV mode to control the TVPress Mode to select the mode you want to set up Searching and sampling the code of a deviceUsing the volume lock feature Operational feature resetRepeatedly press Mode to select CABLE/SAT mode To reset the volume controls to the original device modeVCRs/PVRs Multi-brand remote control device codesCable boxes CD players ReceiversLaser disks DVD playersMenu layout and navigation Main menu layoutSetup / Installation menu layout TV Guide On Screen system setup To set up the TV Guide On Screen systemScreen 3 Do you have Cable service connected? Screen 4 Do you have a Cable box connected?Setting up the TV Guide On Screen system On nextSetting up the TV Guide On Screen system TV Guide On Screen Reminder Setting up your TV Selecting the menu language Configuring the antenna inputTo configure the ANT 1 and ANT 2 input sources To select the menu languageProgramming channels automatically Programming channels into the TV’s channel memoryTo program channels automatically Manually adding and deleting channels in the channel memory Programming your favorite channels To add and delete channels in the Favorite Channels listsTo clear your favorite channel lists To tune your favorite channels for the current ANT inputSetting up and using TheaterNet on-screen device control Setting up TheaterNetTo set up TheaterNet device control To remove a device from TheaterNetTo close the on-screen control icons To select the device’s control icons directlyTo view another source TheaterNet IR device codes AmplifiersLaser disk players Miscellaneous audio devicesVideo accessory Hdtv decoder Receivers VCRsSTS Adjusting the color convergence Manually adjusting the colorAutomatically adjusting the color Convergence using TouchFocusSetting the Avhd device skip time Selecting the Hdmi 1 or Hdmi 2 audio modeTo reset your convergence adjustments To select the Hdmi audio modeSetting the time and date Viewing the CableCARD menuTo set the time and date To view the CableCARD menuViewing the digital signal meter Viewing the system statusTV Guide On Screen system includes the following features To open the TV Guide On Screen systemBelow Rating, stereo, HDTV, new episodeTV Guide On Screen remote control functions Navigating the TV Guide On Screen systemPanel Menus Video WindowTo lock/unlock the Video Window Info Box TV Guide On Screen IconsTV Guide On Screen Services Listings screenSearch screen Example Category searchList of all matching shows for that keyword is displayed To edit or delete a keywordRecordings screen To choose the way recordings are displayedTo view a recording, you can do one of the following Screen a Screen BSet a show to Record from a panel menu Record featuresSchedule screen Manually set a show to Record Recording notification bannerSet a show Reminder from a panel menu Remind featuresManually set a show Reminder Reminder notification banner Change system settings Setup screenChange channel display Change default options General default optionsRecord defaults Remind defaultsSelecting the video input source to view Using the TV’s featuresTo select the video input source to view To label the video input sources Labeling the video input sourcesTo clear the input labels Tuning channels Tuning to the next programmed channelSwitching between two channels using Channel Return Switching between two channels using SurfLockSelecting the picture size Press PIC Size on the remote controlTo select the picture size ¥ None of the picture is hidden TheaterWide 1 picture size For 43 format programTheaterWide 2 picture size for letter box programs Full picture size for 169 480i, 480p source programs onlyUsing the auto aspect ratio feature To set the scroll settingsTo turn on the Auto Aspect feature To turn off the Auto Aspect featureSelecting the display format 480i and 480p signals only To set the Cinema Mode to FilmTo set the Cinema Mode to Video To select the display formatUsing the POP features Using the POP double-window featureTo display a program in the POP window To close the POP windowFreezing the main picture in the POP double-window Switching the speaker audio main or POPTo close the still POP window POP double-window aspect ratio Using the favorite channel scan featureTo scan and tune your favorite channels Adjusting the picture Selecting the picture modeAdjusting the picture quality Resetting the picture settingsUsing the Night Mode feature Using CableClear DNR digital noise reductionSelecting the color temperature Resetting the advanced picture settingsAdjusting the Velocity Scan Modulation To select the color temperatureDigital closed captions Using the closed caption modeAdvanced closed captions Adjusting the audio Digital audio selectorMuting the sound Selecting stereo/SAP broadcastsUsing the StableSound feature Turning off the built-in speakersUsing the SRS WOW surround sound feature Selecting the optical audio output formatUsing the memory card picture viewer Memory card specificationsViewing digital photos on your TV During the slide showTo set the slide show interval To close the picture viewerSetting the ON/OFF timer Using the memory card pictureMemory card care and handling Setting the sleep timer Displaying TV setting information on-screenUnderstanding the auto power off feature Understanding the last mode memory featureUsing the Locks menu Entering the PIN codeIf you cannot remember your PIN code Changing your PIN codeBlocking TV programs and movies by rating V-Chip To block and unblock TV programs and moviesPress z to highlight Edit Rating Limits and press Edit Rating Limits screen below appearsUnlocking programs temporarily Blocking channelsLocking video inputs Using the GameTimer Using the front panel lock featureTroubleshooting ¥ Adjust the picture qualitiesTroubleshooting TV Guide On Screen FAQs LED indicationsSetup How do I resize or close the Info window? Operations What do the frequencies for Record and Remind mean?Specifications AppendixLimited United States Warranty Limited Canada Warranty For 32 and Larger TVs101 Index Channel programming12Ð25 3Ð5Picture adjustments Remote controlPicture-out-picture POP 2Ð5Toshiba America Consumer PRODUCTS, L.L.C 23566378