Welcome
SETUP
SETUP
Other Info
Other Info
Other Info
Audio
Problem | Possible Remedies | |
Good picture, | ❏ | Press MUTING so that Muting disappears from the screen (see page 44). |
no sound | ❏ | Make sure the Speaker option is set to On in the Audio Menu (see page 65). |
|
| |
Cannot gain enough volume ❏ | Increase the volume of the cable box using the cable box’s remote control. | |
when using a cable box |
| Then press TV FUNCTION and adjust the TV’s volume. |
|
|
|
Sound seems weak or | ❏ | The TV’s audio might be set to Auto SAP or Mono, when it might be better set |
insufficient |
| to Stereo. In the Audio Menu (see page 64), set the MTS setting to Stereo. If |
|
| already set to Stereo, switch to Mono (which may reduce background noise |
|
| during weak stereo broadcasts). |
Cannot raise the volume on | ❏ | If the Speaker option is set to Off and the Audio Out option is set to Fixed (in |
external audio speakers |
| order to output the sound to your audio system) use your audio receiver to |
|
| adjust the sound (see page 64). Or, to use the TV remote control, set the |
|
| Audio Out option to Variable. |
| ❏ | To turn on the TV speakers, set the Speaker option to On (see page 64). |
General
Problem | Possible Remedies | |
How to reset TV to | ❏ | Turn on the TV. While holding down the RESET button on the remote |
factory settings |
| control, press the POWER button on the TV. (The TV will turn itself off, then |
|
| back on again.) Release the RESET button. |
|
| |
How to restore Video settings ❏ | Press the RESET button on the remote control while in the Video Menu (see | |
to factory settings |
| page 63). |
|
|
|
How to restore Audio | ❏ | Press the RESET button on the remote control while in the Audio Menu (see |
settings to factory settings |
| page 65). |
|
|
|
Cannot cycle through the | ❏ | Be sure the Video Label option is not set to Skip (see page 73). |
other video equipment |
|
|
connected to the TV |
|
|
|
|
|
Cannot operate Menu | ❏ | If a menu option appears in gray, this indicates that the TV is in a state in |
|
| which the menu option is not available. |
Lost password | ❏ | In the password screen (see page 69), enter the following master password: |
|
| 4357. The master password clears your previous password; it cannot be |
|
| used to temporarily unblock channels. |
|
|
|
LED on front panel is lit | ❏ | The STAND BY LED (see page 12) blinks when the TV is turned on, then |
|
| shuts off when the picture is displayed. If the LED blinks continuously, this |
|
| may indicate the TV needs service. |
| ❏ | The TIMER LED (see page 12) indicates that the timer is set. When the |
|
| timer is set, this LED will remain lit even when the TV is turned off. |
80