Samsung SRD-440 user manual Before Start, Battery

Page 4
CALIFORNIA USA ONLY
This Perchlorate warning applies only to primary CR (Manganese Dioxide) Lithium coin cells in the product sold or distributed ONLY in California USA. “Perchlorate Material - special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate.”

overview

BEFORE START

This user manual provides Information for using the DVR such as brief introduction, part names, functions, connection to other equipment, menu setup, etc.

You have to keep in mind the following notices :

•SAMSUNG retains the copyright on this manual.

•This manual cannot be copied without SAMSUNG’s prior written approval.

•We are not liable for any or all losses to the product incurred by your use of non-standard product or violation of instructions mentioned in this manual.

•Prior to opening the case, please consult a qualified technician first. Whenever this is needed power must be removed from the unit.

•Before installing an additional HDD or connecting an external storage device (USB memory or USB HDD) to this DVR, check the compatibility. Consult your provider for the compatibility list.

Warning

❖Battery

It is essential that when changing the battery in the unit, the replacement battery must be of the same type otherwise there may be a possibility of an explosion.

The following are the specifications of the battery you are using now.

•Normal voltage : 3V

• Normal capacity : 170mAh

• Continuous standard load : 0.2mA

• Operating temperature : -20°C ~ +85°C (-4°F ~ +185°F)

JConnect the power cord into a grounded outlet.

The Mains plug is used as a disconnect device and shall stay readily operable at any time.

Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

❖System Shutdown

Turning off the power while the product is in operation, or undertaking improper actions may cause damage or malfunction to the hard drive or the product.

Please turn off the power using the Power button on the front of your DVR. After selecting <OK> in the pop-up menu, you can pull off the power cord.

You may want to install a UPS system for safe operation in order to prevent damage caused by an unexpected power stoppage. (Any questions concerning UPS, consult your UPS retailer.)

❖Operating Temperature

The guaranteed operating temperature range of this product is 0°C ~ 40°C (32°F ~ 104°F).

This product may not work properly if you run right after a long period of storage at a temperature below the guaranteed one.

Prior to using a device that has been stored for a long period in low temperatures, allow the product to stand at room temperature for a period.

Especially for the built-in HDD in the product, its guaranteed temperature range is 5°C ~ 55°C (41°F ~ 131°F). Likewise, the hard drive may not work at a temperature below the guaranteed one.

4_ overview

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Channel DVR SRD-440Channel DVR Important Safety Instructions  OverviewBattery Before StartContents Search & Play WEB ViewerFeatures Package Contents Standards ApprovalsPart Names and Functions Front Part Names and Functions Rear Using the Numeric buttons Remote ControlChanging the Remote Control ID Installation Checking the Installation EnvironmentConnecting the VIDEO, AUDIO, and Monitor Connecting the USBConnecting POS Device  Connecting with Other DeviceConnecting the Alarm INPUT/OUTPUT Connecting the RS-485 DeviceConnecting the alarm input signal Connecting the alarm output signalConnecting the Network Connecting to Network through Ethernet 10/100BaseTConnecting to the Network using the router  Connecting withConnecting to Network through Adsl Getting Started Starting the systemShutting Down the System  LiveLogin Locking All ButtonsIcons on the Live Screen Live Screen ConfigurationLive Error Information Split Mode MenuSplit Mode Menu Live Screen MenuSingle Mode Menu PTZ Alarm Freeze View the Launcher MenuSystem Date/Time/Language Time. PTZLive Mode Switching the screen modeSwitching the screen automatically PIPChannel Setting Switching to Single ModeSelecting a Spot Out mode Spot OUTZoom Multichannel Live MenuAudio ON/OFF in Single mode You can turn the sound on/off the CH1 in Live modeAudio ON/OFF FreezeCH2 Setting the Date/Time/Language System SetupDate/Time/Language Setting Holiday Using the CalendarSetting the Administrator Using Virtual KeyboardPermission Management Permission Management Using the DVR Setting the GroupTo set the group authority To change the user password To restrict the user permissionsSetting the User Setting PermissionsWhen the user setup is done, press OK SetupSystem Management Checking the System InformationSystem Management System Information Using Updating the SoftwareLog Information SettingsSystem Log Backup Log Event LogUse the up/down buttons Select Event Log Use direction buttonsSetting the Device Setting the CameraCamera Press Enter buttonTo set the privacy zone Screen SetupClear All Selected cell is removed from the Privacy Region Storage Device Setting the PTZConfirming Devices HDD Alarm HDD AlarmFormatting You can format a storage deviceRemote Devices POS DevicesItem, and press Enter button Remote DeviceAdd Preset Preset SetupSetting Display position Setting the MonitorMonitor Setting the Spot Out Setting the Screen ModeSetting the Recording Recording ScheduleRecord Recording ScheduleREC Quality / Resolution Setting Standard Recording PropertiesEvent Record Duration Recording Color TagsSetting Event Recording Properties Record OptionSetting the Event Window of sensor detection setup appearsSensor Detection Detection, and press Enter buttonSetting the Motion Detection Area Motion DetectionAlarm Schedule Window of video loss detection area setup appearsAlarm Schedule Video Loss DetectionBackup Setting the BackupYou can backup the desired data to a connected device BackupNetwork Configuration Connection ModeSetting the Connection You can set the network connection route and protocolMove to Connection Mode, and press Enter Setting the ProtocolProtocol Connecting and Setting the Network When no router is usedWhen a router is used Internal Port Range Set the same to the External Port RangeLive Transfer Ddns SettingLive Transfer Smtp Setting Mailing ServiceEvent Setting Group Setting Recipient SettingWhen the recipient setting is done, press OK RecipientUsing the PTZ camera Controlling a PTZ DevicePTZ Device Getting started with PTZPreset Setting Camera SettingIt does not appear in Backup Search SearchTime Search You can search for recorded data of a desired timeEvent Search Backup SearchSearch & Play POS Search Motion SearchSelect POS Search in the Search menu POS SearchBackup Range PlaybackPlay  For data search, refer to Search.Using the Playback Button REC Records all channels in Live mode Partial BackupMode Switch DVR setWhat is Web Viewer? Product FeaturesIntroducing WEB Viewer System RequirementsConnecting WEB Viewer Click InstallUsing Live Viewer You can change the split mode by clicking each number icon Single ModeOSD Information Display SPLIT-SCREENChanging the Live Screen Mode Setting the display of the OSD time informationConnected DVR Saving the Live Screen on the PC Capture Saves the current screen into a BMP or Jpeg fileUsing PTZ Camera Changing the Live Screen ChannelWeb viewer Using Search Viewer SPLIT-SCREEN Saving the Live Screen on the PC Searching the Recorded Video in the Calendar Searching the Recorded Video in the TimelineViewer Setup You can configure the various settings of the DVR systemSystem Controlling PlaybackHoliday Permission ManagementSystem Management Device CameraRemote Device Storage DevicePOS Device Monitor For more information, refer to Setting the Recording. RecordRecording Schedule Event Record DurationREC Quality & Resolution EventRecord Option Sensor DetectionAlarm Schedule You can set the alarm output time if a video loss occursMotion Detection Video Loss DetectionFor more information, refer to Network Configuration. You can check the Ddns settingsNetwork ConnectionLive Transfer Mailing ServiceSmtp About What is Mobile Viewer? Key FeaturesMobile Viewer Compatible SmartphoneSEC Backup Viewer Recommended System Requirements Backup Viewer SEQUENCE, PIP Product SpecificationRTP, RTSP, HTTP, CGI 500GB Sata HDD HdmiERNA/GE/VCL TP/VICON/ELMO  AppendixProduct Overview Default Setting 43219600 Category Details Factory DefaultDuration 192.168.1.200 192.168.1.1255.255.255.0 168.126.63.1Troubleshooting HDD installed. Try again with a different HDD By the service personnelSplit mode Icon on the launcher to switch to Live mode4CIF 2CIFCIF Open Source License Report on the Product PreambleVersion 2, June USAPage No Warranty Some devices are designed to deny users access to How to Apply These Terms to Your New ProgramsGNU Lesser General Public License instead of this License Terms and Conditions Source CodeConveying Verbatim Copies Additional Terms Acceptance Not Required for Having Copies Automatic Licensing of Downstream RecipientsUse with the GNU Affero General Public License PatentsRevised Versions of this License Interpretation of Sections 15 Limitation of LiabilityEND of Terms and Conditions Page Modified work must itself be a software library Page How to Apply These Terms to Your New Libraries OpenSSL License Original SSLeay LicensePage Correct disposal of batteries in this product Sales Network Chertsey, Surrey, United Kingdom KT16 OPS
Top Page Image Contents