•Focus : Enables you to adjust the focus manually.
•Auto Pan : The camera automatically runs between the two points that you selected.
•Scan : The camera moves to the preset points in the specified sequence.
If multiple presets are specified, the PTZ camera will automatically move to all of the preset points one at a time.
•Pattern : Makes the PTZ camera remember and follow the past route.
The functions of Auto Pan, Scan and Pattern are supported in the protocols of Samsung, Panasonic and Pelco, and are different in terms of the name and setting, depending on the protocols of Samsung, Panasonic and Pelco.
(Panasonic : Auto Pan, Sequence, Sort / Pelco : Auto Pan, Frame Scan (Scan), Pattern)
M Before entering the PTZ device control mode, set the values of the PTZ device in the <Setting the PTZ> menu. (Page 40)
Preset Setting
A preset is a set of specific target points of a PTZ camera, and up to 20 presets per a camera can be stored.
Using the mouse may help make setup easier.
1.In PTZ Control mode, use the direction buttons to adjust the camera in a desired direction.
2.Select the <Save> key.
The virtual keyboard for inputting the preset will appear.
Refer to “Using Virtual Keyboard”. (Page 30)
•Save : You can save the preset settings.
•Rename : You can change the settings of the existing presets.
•Delete : Deletes the selected preset.
•Delete All : Deletes all existing presets.
M If you replace the camera of the channel that stores the preset list with a new one, you should reset the preset accordingly.
3.Press <OK>.
The preset will be saved as a name that you entered.
Camera Setting
A PTZ camera has its own menu system. Optimize the PTZ camera according to the DVR.
Using the mouse may help make setup easier.
USING THE DVR
1.Connect the PTZ camera to the DVR and run the PTZ camera again to display the camera’s protocol setting window.
2.Check the protocol ID of the camera.
In “Device > Setting the PTZ”, enter the PTZ camera ID in the ID input box of the channel that is connected to the PTZ camera. (Page 40)
3.Select <Camera Setup> in the PTZ Control menu. The
You can configure the settings of only those cameras that support the protocols of Samsung, Pelco D/P, AD and Panasonic.
If you are setting Auto Pan or Pattern in the camera menu, press and hold the appropriate button for a certain time so that the button operation can be different from that in normal PTZ setting.
SAMSUNG PROTOCOL
ADDR 0
TYPE RS-485,HALF BAUD 9600
LENS OK!
TILT OK!
PAN OK!
| ||
** MAIN MENU ** | ||
| CAMERA SET... | |
| VIDEO SET... | |
| PRESET... | |
Camera Setup | ZONE SET... | |
AUTO SET... | ||
| ALARM SET... | |
OTHER SET... | ||
| ||
| CLOCK SET... | |
Exit | SYSTEM INFO... | |
English _61