Samsung SRD-440 user manual Setting the Motion Detection Area

using the DVR

Motion Detection

You can set target detection region and motion, as well as the alarm signal output.

When the motion detection region is set, it detects motion within the area.

Using the mouse may help make setup easier.

1.	Use the up/down buttons (	) in <Event> window to	Motion Detection
	move to <Motion Detection>, and press [ENTER] button.
			CH	Mode 		Sensitivity 		Alarm 	Alarm Duration 
	A window of motion detection area setup appears.
2.			1	OFF		Level10(High) 		None	10 sec	
	Use direction buttons (	) to move to a desired	2	OFF		Level10(High) 		None	10 sec	
			4	OFF		Level10(High)		None	10 sec	
			3	OFF		Level10(High)		None	10 sec	
	item, and set the value.

•Mode : Sets whether to activate motion detection.

•Sensitivity : Sets the sensitivity level of the motion detection.

Motion Region

•Alarm : Sets the alarm output method.

	For further information on alarm output, refer to “HDD Alarm >	OK	Cancel
	Alarm”. (Page 41)

•Alarm Duration : Sets the duration of alarm signal and alarm sound.

3.When the motion detection setup is done, press <OK>.

Setting the Motion Detection Area

Select <Motion Region>.

When “Motion Region” window appears, select a channel for detection and set the area of motion detection.

•To set the area in “Motion Region” window

In the “Motion Region” window, select desired region		Motion Region
from <	>.
		CH1
• To set the area using <Individual> selection			Individual Apply to All CH
			OK Cancel

In the “Motion Region” window, you can select cells individually by using <Individual>.

When selected <Individual>, “Motion Region” window disappears and you can select cells one by one. When the motion area setup is done, Right-click to select <Menu> in the context menu or the [MENU] button on the remote control to display the “Motion Region” window again.

-Select : Selected cell is set to be a part of motion detection area.

-Unselect : Selected cell is removed from the motion detection area.

-Inverse : Unselected cells are set to be the motion detection area.

-Menu : After selecting individual motion areas, move to the “Motion Region” window.

If selected <Apply to All CH>, selected motion area is applied to all channels.

When the motion detection setup is done, press <OK>.

Select

Unselect

Inverse

Menu

50_ using the DVR