Atlas OCAP M1056.fm Page 19 Wednesday, April 30, 2008 2:52 PM |
NOTE: You can program up to 15 key presses into one macro.
5.Press and hold SETUP until it blinks twice.
6.To add another macro, repeat steps 1 through 5, substituting the new key sequence to be added in step 4.
NOTE: Programming more than five macros on the same macro key overwrites previous settings.
Clearing a Macro Key
1.On the remote control, press and hold SETUP
until it blinks twice.
2.Enter 9 9 5. The SETUP key blinks twice.
3.Press the macro key you want to clear once.
4.Press and hold SETUP until it blinks twice.
This macro key is now clear and ready for reprogramming (see “Programming a Macro Key” on page 18). If desired, repeat these to clear another Tune- In key.
USING THE MASTER POWER KEY
The Atlas OCAP
NOTE: | MASTER POWER (PWR) only works in the CBL |
| mode. If it is not programmed, only the cable |
| converter will turn on or off. In any other |
| mode, pressing MASTER POWER (PWR) once |
| will turn the selected device on or off. |
Programming the Master Power Key
1.On the remote control, press and hold SETUP
until the
www.urcsupport.com/atlasocap
19