Analog Input #6
This analog input is reserved for Duct Static Pressure. This value can then be used to monitor the duct static or to actually control the duct static using an analog output and driving either inlet vanes or a VFD controller. It is not recommended that you attempt to use relays to control the duct static pressure, although this reading can be selected as a control source on the relay configuration screen.
CAUTION: If you select two relays to control duct static, WattMaster Controls cannot assume any liability for equipment damage caused by
If you require a Duct Static Pressure Sensor, you must use an OE271 sensor provided by WattMaster Controls for proper sensor readings. No other sensors are currently supported for this input.
All setpoints related to duct static control pressures and alarm points are programmed on this screen which activates when you
10