Clifford 50.7X Runtime check, Runtime reset, Still enabled, Then Feedback Remote start on tones

still enabled).

You can still remote start the vehicle after the turbo timer has timed out and shut off the vehicle. For safety reasons, if a door is opened or if the

ALARMMIS TRIGGEREDGWHILEIYOUOARERAWAYTHEHREMOTE STARTTEXITSITHE MANUAL transmission mode and does not remote start until the MTS sequence is re-initiated.

Note: An optional push button can be hard wired to the (-) activation

INPUTP( ON THEHREMOTE START 4HIS ALLOWS THEHUSER TO ACTIVATE THEH turbo timer without having to use the remote.

When the vehicle is running follow the procedures listed above, but instead of pressing the remote, press the push button the appropriate number of times to activate the remote start (factory setting is for 1 pulse). The remote emits the remote start confirmation tone, after which

YOUOCANATURNNOFFFTHEHIGNITION ANDNEXIT THEHVEHICLE 4HEHCARAREMAINS RUN- ning for the pre-programmed amount of time.

Runtime check

Command: While the remote start is running, press two-times, and then Hold for 1.5 seconds.

Feedback: 4EXTXREADSRRUNTIMESANDRDISPLAYS TIME LEFT

Notes: This feature is only available on the 2way remote.

Runtime reset

Command: While the remote start is running, press one-time and

then .

Feedback: Remote start ON tones.

Notes: Re-starts the remote start runtime counter if remote start is active. Note: If remote start is not active, the 2-WAY