Diagnostics
The microprocessor at the heart of your system is constantly monitoring all of the switches and sensors connected to it. It is designed to detect any faulty switches and sensors and prevent them from disabling the entire system. The microprocessor will also record and report any trig- gers that occurred during your absence.
Refer to System Status Chirps and Table of Zones sections of this guide for diagnostic information.
Last trigger
Press 
three times and then hold for 1.5 seconds. The display scrolls last trigger and the remote recalls the last zone that has triggered the security system.
Arming
If the security system is armed at the same time that an input is active (such as a door opening or sensor triggering), you will hear one siren chirp to indicate arming and a second siren chirp to indicate Bypass Notification.
A Bypass Notification chirp means that the security system ignores the input that was active when the system was armed, until that input ceases. Three seconds after that input ceases, the security system will resume normal monitoring.
For exampleIF YOUR VEHICLEIHASAAN INTERIOR LIGHTGEXIT DELAYLANDNYOUOARMM your security system before the interior light turns off, you may hear a second Bypass Notification chirp.
Once the light turns off, however, the security system resumes normal monitoring.
© 2008 Directed Electronics. All rights reserved. | 41 |