remote will respond with error tone.
Rear defogger
Command: Press four times, and then . (Only after remote start is on.)
Feedback: $EFOGGER ICON APPEARSEON REMOTE ANDNTEXT READSA$EFROSTR
On.
Notes: While the remote start is running the defroster will manu- ally be turned on for one remote start cycle. When the remote start shuts down, the defroster will work normally. The defroster turns on when the temperature inside the vehicle is 55 degrees or below when this feature is wired and enabled.
Smart start
Command: Press three-times and then press .
Feedback: 4HEHVEHICLES PARKINGKLIGHTGmASH TIMESMFAST ANDNTHEHTEXT on the 2way remote reads Smart Start On
Notes: Enables or disables the SmartStart feature. The smart start feature of this system will allow you to have the remote start activate when the vehicle reaches a certain temperature (hot or cold) or a certain voltage. The fac- tory setting for temperature high is 100 °F the setting for low is 0 °&4HE4VOLTAGEVSETTINGAIS FOR 6
These settings can be adjusted or turned off by your installer when using the Bitwriter.
To activate the Smart Start Mode with a manual transmission:
1.Enter the MTS procedure.
2.%XIT THEHVEHICLEIANDNPRESSETHEH button on the remote (the vehicle
32 | © 2008 Directed Electronics. All rights reserved. |