Clifford 50.7X manual Control Center

Page 6

Control Center

4O SATISFYI&###2& EXPOSURE COMPLIANCE REQUIREMENTS ETHEHDEVICE ANDNITSTANTENNAE must maintain a separation distance of 20 cm or more from the person’s body,

EXCEPT FOR THE HANDRANDTWRISTS HTO SATISFY 2&DEXPOSURE COMPLIANCEE

This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harm- ful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device.

WARNING! #HANGESNOR MODIlCATIONS NOTOEXPRESSLYEAPPROVED BY THEHPARTY RE- sponsible for compliance could void the user’s authority to operate this device.

6

© 2008 Directed Electronics. All rights reserved.

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
Responder LC Model Security and Remote Start Owner’s Guide Page Contents Way remote Remote Controls Government regulationsControl Center Directed Electronics. All rights reserved Directed Electronics. All rights reserved Directed Electronics. All rights reserved Ss Window decals Ss Your warranty registration What is includedYour warranty Important informationReplacement remote controls Out of Range notification System maintenanceCharging the Battery Low battery indicatorBecomesooperationalpwhileastillodisplaying #!2% Two Way Remote Battery ReplacementMulti-car control capability One Way RemoteResponder LC 2-Way LC 1-way companion RM,OCKDirected Electronics. All rights reserved Using the system If errors are found when armingArm Command Press one time to Disarm DisarmRemote Start Valet Take-Over Etein Without Steppingoon the BRAKEP7HEN EXITINGT6ALET Mode THEH5NLOCK Valet modeFactoryydefaultaicon Andntext is TRUNK Function shiftCommand Press three-times and then Car finderTurn the ignition key on and then off Cabin temperature Full Alarm Trigger Additional arming featuresArm Features While the system is armedUardashock Sensor  Sponse will reset To disarm the system without a remote controlSystem override Modified Arming Modes Disarm Features Will beep once Silent Mode 2 Turning off the sirenSilent disarm Additional remote start features Manual Transmission%XIT the VEHICLE Press Timer modeEnables or disables the remote start timer mode 3TOP OFPTHEO6EHICLE While INW4IMER MODE%XIT the Vehicle and ARMMTHETSYSTEM Turbo Timer modeTurn off the ignition car stays running Times, and thenRuntime check Runtime resetStill enabled Then Feedback Remote start on tonesEnter the MTS procedure Remote will respond with error toneCommand Press three-times and then press Rear defoggerDirected Electronics. All rights reserved Feedback 4HEHSCREEN Willeshow a Textlof the Itemwactivatede Auxiliary featuresAux Feedback 4EXTXWILL Display the ItempactivatedtRemote control feature programming Remote setup options 6IBEMenu option descriptions Ss Auto keypad lockPress the AUX button to move up the menu, press Sensor adjust Pair Remote ModeDemo Mode Safety features Starter anti-grind circuitryDisabling the remote start system Diagnostics Last triggerArming Disarming System status chirpsInterpreting zone diagnostics Table of zonesNuisance prevention circuitry Remote StartOwner recognition Rapid resume logicPower saver mode SystemWay remote Programming options Directed Electronics. All rights reserved Security & convenience expansions Audio Sensor Metal on glass, glass cracking, and breakingDirected Electronics. All rights reserved Glossary of terms To the vehicle or glass Or DAMAGED MOR Toeenter or EXITT6ALET -ODELCD layout ALLThis feature is not available 6IBRATION /NQuick reference guide Disarming without a remoteLocation of Shutdown Toggle Switch Limited lifetime consumer warranty % -!8-5- %84%.4 !,,/7%$/ 9 ,!7 !,, 7!22!.4%3 4 .#,5$6EHICLE Identification Number Page Company behind this system is Directed Electronics