Mitsubishi Electronics WD-52627, WD-62627 manual Appendix G Cleaning and Service

Page 108

Appendix G: Cleaning and Service

IMPORTANT

DO NOT use any kind of abrasive cleaner on the surface of the TV screen.

Cleaning

Normally, light dusting with a dry, non-scratching duster will keep your TV clean. If cleaning beyond this is needed, please use the following guidelines:

First, turn off the TV and unplug the power cord from the power outlet.

Top and Sides of the TV:

Gently wipe down your TV with a soft, non-abrasive cloth such as cotton flannel or a clean cloth diaper, lightly moistened with water. Dry with a second dry, soft, non-abrasive cloth.

For oily dirt, add a few drops of mild liquid detergent, such as dishwashing detergent, to the water used to moisten the cloth. Rinse with a second cloth moistened only with water. Dry with a third dry, soft, non-abrasive cloth.

Screen:

Follow the instructions for the top and sides, however, wipe gently in an up and down motion, following the grooves in the screen.

Clean the entire screen evenly, not just sections of the screen.

Do not allow liquid to drip down the grooves of the screen, as some liquid may enter the TV between the screen and the screen frame.

You may purchase Mitsubishi Screen Cleaner, part number CLEANER-VSS, by calling (800) 553-7278.

General Cleaning Warnings:

DO NOT allow liquid to enter the TV through the ventilation slots or any crevice.

DO NOT use any strong or abrasive cleaners as these can scratch the surfaces.

DO NOT use any cleaners with ammonia, bleach, alcohol, benzine, or thinners as these can dull the surfaces.

DO NOT spray liquids or cleaners directly on the TV’s surfaces.

DO NOT scrub or rub the TV harshly. Wipe it gently.

Service

If you are unable to correct a problem with your TV, consult your Mitsubishi dealer or a Mitsubishi Authorized Warranty Service Center.

DO NOT adjust any controls other than those described in this Owner’s Guide.

DO NOT remove the protective back cover of your TV.

Menus not described and shown in this owner’s guide are designed for factory use and for authorized service personnel. Damage caused to the TV by non-authorized changes or changes to these menus made by non-authorized persons are not covered under warranty.

108 Appendices

Image 108
Contents Owner’s Guide TV Guide On Screen Access Requirements Lamp ReplacementWhile Under Warranty After Warranty Stand RequirementFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Our Thanks Mitsubishi Digital Electronics America, IncRemote Control TV Accessories Special Features Front Control PanelTV Accessories      Special Features System Reset ResetFront-Panel Indicator Lights Power/Timer IndicatorStatus Indicator Lamp IndicatorRemote Control OverviewBattery Installation Sleep TimerCare IR Emitter NetCommand TV Back PanelInput 1 Component 1, 2, and 3 InputsHdmi 1 DTV Link/IEEECableCARD Slot Digital Audio OutputMedia Card Slots and Front-Panel Inputs Media Card SlotsFront-Panel Input Card CompatibilityDemo Mode Using the System Reset ButtonUsing the Reset Menu to Reset Additional InformationPage Connecting Connecting External Devices and NetCommand Setup Stereo and/or digital audio cables AV ReceiverUsing a CableCARD CableCARD TechnologyCableCARD Technology Connecting a Wall Outlet Cable or Cable Box Wall Outlet CableStandard Cable Box Antenna with a Single Lead Antennas with Separate UHF and VHF LeadsFor antennas with flat twin leads For cable or antenna with coaxial leadVCR to an Antenna or Wall Outlet Cable Audio & Video $BCMFConnecting a VCR to a Cable Box Audio & Video VCR to a Cable Box Audio & VideoReceiver Stereo System Satellite Receiver or Other Device with S-VideoTo connect an analog A/V receiver DVD Player with Component Video DVI DeviceHdtv Cable Box or Satellite Receiver with Component Video Hdmi DeviceConnecting a Computer with an Hdmi or DVI Monitor Output Computer with an Hdmi Monitor OutputComputer with a DVI Monitor Output Connecting the IR Emitter NetCommand An IR emitter cable is included with the TVConnecting Compatible Ieee 1394 Devices When Connecting Ieee 1394 DevicesCompatible Ieee 1394 Devices Pin Style vs -Pin Style Connectors Connection StylesDirect Device-To-Device Style Hub Connection StyleHelpful Hints Page NetCommand Setup and Editing NetCommand Introduction Welcome To NetCommandUsing the Remote Control with NetCommand NetCommand Pre-Memorized DevicesNetCommand Setup On-Screen Buttons Remote Control Buttons 3D GraphicalNetCommand Initial Setup NetCommand Information ScreenSetup Reminder Welcome ScreenDevice Setup Screen Review Screen Finish ScreenEdit NetCommand Add an A/V Receiver Receiver ScreenReceiver Inputs Receiver AVR Input Learn Screen Receiver AVR Learn ScreenName Screen Audio Output to AVR ScreenEdit NetCommand Add Devices Edit NetCommand ScreenAdd Screen Device Screen Device Learn ScreenDevice Advanced Learn Screen Connection for Device ScreenVCR for Recordings Screen RF Connection for Cable ScreenIR Code for Device Screen Edit NetCommand Change or Delete Devices Change Device ScreenDelete Device Screen Ieee 1394 Devices and NetCommand- Controlled Recordings Ieee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyName for 1394 Device Screen New 1394 Device ScreenIeee 1394 Device Type Screen Connection ScreenPower On/Off Devices Device Selection MenuPIP Device Selection Menu Using the Device Menu Button to Display Menus Device MenuIR Controlled Devices Moving Through Other CableCARD ScreensUsing the Guide Button to Display ChannelView and Menus Guide ButtonGuide and the Device Selection Menu Guide and the Record To MenuNetCommand-Controlled Recordings Setting up RecordingsTime-Delayed Recording Recording NowRecord List, Peer-to-Peer Connections Using A/V Discs Using A/V DiscsDirect VCR Recording from an Antenna or Cable Source Copy-Protected MaterialTV Menu Screen Operations Main Menu Setup Menu LanguageMemorize Channels ClockTimer On/Off DateTime Zone Daylight Savings TimeNetCommand Menu Remote Control Transport ButtonsEdit Transport MenuRecording Setup Time-Delayed RecordingRecord Menu RecordDefault Digital Record Device Setting Up Analog Recordings with TV Guide On ScreenCancel Current Recordings Analog RecordingsChannel Menu AntennaPrefer Digital MemorySignal Strength SQV SuperQuickViewDigital Settings Captions MenuAnalog Captions BackgroundFonts SizeColor Opacity FontChip Lock Menu ChipEntry Chip Start Time and V-Chip Stop TimeChip Signal Information Content CategoriesPrograms without V-Chip signals Chip Lock Menu V-Chip DefinitionsLock By Time Front Button LockAudio/Video Menu Setting Descriptions Audio Analog and Digital Audio SettingsAnalog-Only Audio Settings Digital-Only Audio SettingsSetting Descriptions Video Video SettingsAuto Position HorizPosition Horizontal PositionVertPosition Vertical Position Fine DetailAdditional Features MediaCommand and Media Card PlaybackOperation of PIP Signal and Format Definitions TV Display FormatsDVD Definitions Anamorphic or Enhanced for Wide-Screen TV’s57%JTQMBZ PC resolution XGA selection PC ViewingSignal Format 16 X 9 Standard Signal Format Standard ZoomPC Display Formats MediaCommand and Media Card Playback Inserting a media cardDon’t pull the media card out while it is playing For MP3 or WMA Audio PlaybackMedia Command and Media Card Playback Troubleshooting Troubleshooting Problem Possible SolutionThere is a large black or gray rectangle on Devices are grayed out in the Device Selection All Ieee 1394 devices disappear Troubleshooting Appendix H Lamp Cartridge Replacement Appendix B SpecificationsAppendix G Cleaning and Service Appendix a Bypassing the V-Chip LockPage Appendix a Bypassing the V-Chip Lock Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Appendix B Specifications TV SpecificationsInputs Outputs Appendix C Remote Control Programming Codes Programming the Remote to Control NetCommand A/V ProductsDVD Players TV position Cable/SAT/DTV positionVCR position DVD positionAppendix D Device Control with NetCommand NetCommand Compatible Traditional Devices AnalogWhen an Ieee 1394 Device is Viewed or Played Ieee 1394 DevicesAppendix E NetCommand Specialized Device Keys Appendix F On-Screen Information Displays Analog ProgramDigital Program Digital Ieee 1394 DeviceAppendix G Cleaning and Service Appendix H Lamp Cartridge Replacement Lamp LifeBurn Danger Do not touch the glass parts of the lamp cartridgeTrademark and License Information Mitsubishi TV Software Index VCR Mitsubishi DLP Projection Television Limited Warranty 115This Limited Warranty does not Cover 116Page MDEAservice@mdea.com Website Mail
Related manuals
Manual 86 pages 7.9 Kb