Mitsubishi Electronics WD-62627, WD-52627 Appendix B Specifications, TV Specifications, Inputs

Page 99

Appendix B: Specifications

From time to time, Mitsubishi may offer software updates to expand the features or operation of this TV. When these updates are available they will be announced on our web site, Mitsubishi-tv.com. If you return your Owner’s registration card, with your model and serial number, you may receive written notification of available software updates.

TV Specifications

Projection System	DLP, 0.843” chip, 1920 x 1080 pixels with Smooth Picture™

Lamp	120 watt VIP type

Channel Frequency Reception	Over-the-Air: VHF 2 - 13, UHF 14 - 69
	Analog Cable: 1 - 125
	Digital Cable: 1 - 135

Channel Type	Over the Air: Analog NTSC, Digital ATSC with sub-channels
		(all 18 video formats)
	Cable:	Analog NTSC (non-scrambled)
		Digital QAM 64 and 256 with sub-channels (non-
		scrambled)
	CableCARD™: Authorized scrambled and non-scrambled digital
		channels

Note for Digital Channels: The channel numbers displayed on screen are determined by the broadcaster or cable company and can vary from the standard frequency number. If there is no channel number information included from the broadcaster or cable company, then the TV will create a channel number based on the frequency number as the

main channel number and the program number as the sub-channel number. When using an authorized CableCARD,
the channel numbers are determined by the cable company.

Inputs
Antenna/Cable input Qty. 2	F connector, 75-ohm

HDMI (digital video/audio), Qty. 2	HDMI standard connector
Signal Type	HDMI standards for digital audio and video.
	HDMI 1: Not intended for use with personal computers.
	HDMI 2: Accepts PC input.
	VGA (640 x 480), 60Hz
	W-VGA (848 x 480), 60 Hz
	SVGA (800 x 600), 60Hz
	W-SVGA (1064 x 600), 60Hz
	XGA (1024 x 768), 60 Hz
	1280 x 720, 60 Hz (EIA standards)

Video/S-Video, Qty. 3 each	Video: RCA Pin Plug, 1.0 V p-p, 75 ohm
	S-Video: Four Pin Din Plug
	Y: 1.0 Vp-p 75 ohm
	C: 0.286 Vp-p (burst signal), 75 ohm
Signal Type	NTSC 480i only

Component Video (Y/Pr/Pb) Qty. 3 sets	RCA Pin Plug (EIA-770.3 Standard Levels and Timing)
	Y: 1.0 Vp-p (includes sync), 75 ohm
	Pr: 700 mV p-p, 75 ohm
	Pb: 700 mV p-p, 75 ohm
Signal Type	EIA-770.1 & EIA 770.2 480i, 480p, EIA 770.3 720p and 1080i (video
	standards)

Audio Inputs: Qty. 8 pairs	RCA Pin Plug 500 mV (full scale), 43 k ohm

Appendices 99

Image 99

Contents Owner’s Guide Stand Requirement TV Guide On Screen Access RequirementsLamp Replacement While Under Warranty After WarrantyFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksTV Accessories Special Features Front Control Panel Remote Control TV AccessoriesSpecial Features Power/Timer Indicator System ResetReset Front-Panel Indicator LightsLamp Indicator Status IndicatorOverview Remote ControlBattery Installation Sleep TimerCare Component 1, 2, and 3 Inputs IR Emitter NetCommandTV Back Panel Input 1Digital Audio Output Hdmi 1DTV Link/IEEE CableCARD SlotCard Compatibility Media Card Slots and Front-Panel InputsMedia Card Slots Front-Panel InputAdditional Information Demo ModeUsing the System Reset Button Using the Reset Menu to ResetPage Connecting Stereo and/or digital audio cables AV Receiver Connecting External Devices and NetCommand SetupUsing a CableCARD CableCARD TechnologyCableCARD Technology Connecting a Wall Outlet Cable or Cable Box Wall Outlet CableStandard Cable Box For cable or antenna with coaxial lead Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For antennas with flat twin leads$BCMF VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoReceiver Stereo System Satellite Receiver or Other Device with S-VideoTo connect an analog A/V receiver DVI Device DVD Player with Component VideoHdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoConnecting a Computer with an Hdmi or DVI Monitor Output Computer with an Hdmi Monitor OutputComputer with a DVI Monitor Output An IR emitter cable is included with the TV Connecting the IR Emitter NetCommandConnecting Compatible Ieee 1394 Devices When Connecting Ieee 1394 DevicesCompatible Ieee 1394 Devices Hub Connection Style Pin Style vs -Pin Style ConnectorsConnection Styles Direct Device-To-Device StyleHelpful Hints Page NetCommand Setup and Editing Welcome To NetCommand NetCommand IntroductionNetCommand Pre-Memorized Devices Using the Remote Control with NetCommandNetCommand Setup On-Screen Buttons 3D Graphical Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Setup ReminderDevice Setup Screen Finish Screen Review ScreenEdit NetCommand Add an A/V Receiver Receiver ScreenReceiver Inputs Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenEdit NetCommand Add Devices Edit NetCommand ScreenAdd Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenVCR for Recordings Screen RF Connection for Cable ScreenIR Code for Device Screen Edit NetCommand Change or Delete Devices Change Device ScreenDelete Device Screen Ieee 1394 Devices and NetCommand- Controlled Recordings Ieee 1394 Devices and NetCommand Control New 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically Name for 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenPower On/Off Devices Device Selection MenuPIP Device Selection Menu Moving Through Other CableCARD Screens Using the Device Menu Button to Display MenusDevice Menu IR Controlled DevicesGuide and the Record To Menu Using the Guide Button to Display ChannelView and MenusGuide Button Guide and the Device Selection MenuRecording Now NetCommand-Controlled RecordingsSetting up Recordings Time-Delayed RecordingRecord List, Peer-to-Peer Connections Copy-Protected Material Using A/V DiscsUsing A/V Discs Direct VCR Recording from an Antenna or Cable SourceTV Menu Screen Operations Main Menu Clock Setup MenuLanguage Memorize ChannelsDaylight Savings Time Timer On/OffDate Time ZoneTransport Menu NetCommand MenuRemote Control Transport Buttons EditRecord Recording SetupTime-Delayed Recording Record MenuAnalog Recordings Default Digital Record DeviceSetting Up Analog Recordings with TV Guide On Screen Cancel Current RecordingsMemory Channel MenuAntenna Prefer DigitalSQV SuperQuickView Signal StrengthBackground Digital SettingsCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Start Time and V-Chip Stop Time Chip Lock MenuChip EntryChip Lock Menu V-Chip Definitions Chip Signal InformationContent Categories Programs without V-Chip signalsFront Button Lock Lock By TimeAudio/Video Menu Digital-Only Audio Settings Setting Descriptions AudioAnalog and Digital Audio Settings Analog-Only Audio SettingsVideo Settings Setting Descriptions VideoFine Detail Auto PositionHorizPosition Horizontal Position VertPosition Vertical PositionMediaCommand and Media Card Playback Additional FeaturesOperation of PIP Anamorphic or Enhanced for Wide-Screen TV’s Signal and Format DefinitionsTV Display Formats DVD Definitions57%JTQMBZ PC Viewing PC resolution XGA selectionSignal Format 16 X 9 Standard Signal Format Standard ZoomPC Display Formats For MP3 or WMA Audio Playback MediaCommand and Media Card PlaybackInserting a media card Don’t pull the media card out while it is playingMedia Command and Media Card Playback Troubleshooting Problem Possible Solution TroubleshootingThere is a large black or gray rectangle on Devices are grayed out in the Device Selection All Ieee 1394 devices disappear Troubleshooting Appendix a Bypassing the V-Chip Lock Appendix H Lamp Cartridge ReplacementAppendix B Specifications Appendix G Cleaning and ServicePage Appendix a Bypassing the V-Chip Lock Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Appendix B Specifications TV SpecificationsInputs Outputs Programming the Remote to Control NetCommand A/V Products Appendix C Remote Control Programming CodesDVD Players DVD position TV positionCable/SAT/DTV position VCR positionNetCommand Compatible Traditional Devices Analog Appendix D Device Control with NetCommandIeee 1394 Devices When an Ieee 1394 Device is Viewed or PlayedAppendix E NetCommand Specialized Device Keys Digital Ieee 1394 Device Appendix F On-Screen Information DisplaysAnalog Program Digital ProgramAppendix G Cleaning and Service Lamp Life Appendix H Lamp Cartridge ReplacementDo not touch the glass parts of the lamp cartridge Burn DangerTrademark and License Information Mitsubishi TV Software Index VCR 115 Mitsubishi DLP Projection Television Limited Warranty116 This Limited Warranty does not CoverPage Website Mail MDEAservice@mdea.com

Related manuals

Manual 86 pages 7.9 Kb