Adding IEEE 1394 Devices Automatically, continued
IEEE 1394 Device Type Screen
Figures 3 and 4
If the new IEEE 1394 device is also connected using analog inputs, you will need to define the device type. Select the type of device, such as a VCR.
Connection Screen
Figure 5
Select the TV input that you used when you connected the video or
The playback and record control of some DV camcorders may still operate by the IEEE 1394 cable automatically, even though you must use the video or
Figure 3. IEEE 1394 Device Type screen
Once the device type is selected, then the Device screen is displayed so the manufacturer can be selected. If the manufacturer is listed, then you may be able to control this device while it is operating as an analog VCR. For example, if the IEEE 1394 device you have added is
a Mitsubishi DVCR, and you have selected an analog connection as a second connection, then you will select Mitsubishi for the manufacturer. If the manufacturer is not listed, select “Other” and use the Learn screens
Be sure to place an IR Emitter in front of the remote control sensor, just as you have done for other NetCommand® devices. It is necessary to use the IR Emitter only when the DVCR is being used as an
Figure 5. Connection screen
Finish Screen
Figure 6
To finalize your selections and complete the NetCommand setup, select Finish from the Finish screen.
Figure 4. Device screen
Figure 6. Finish screen
56 | Chapter 4. IEEE 1394 Devices and |