Mitsubishi Electronics WD-62627 Antenna with a Single Lead, For antennas with flat twin leads

Page 25

Connecting an Antenna with a Single Lead or Antennas with Separate UHF and VHF Leads

Antenna with a Single Lead

(not for use with CableCARD™)

Figure 3

For antennas with flat twin leads

A300-Ohm to 75-Ohm transformer is required. This is not included with the TV, but is available at most electronics stores.

1.For an antenna with flat twin leads, connect the

300-Ohm twin leads to the 300-Ohm to 75-Ohm transformer.

2.Push the 75-Ohm side of the transformer onto ANT-1 MAIN on the TV back panel.

For cable or antenna with coaxial lead

Connect the coaxial lead directly to ANT-1 MAIN on the TV back panel.

 

 

57CBDLQBOFMTFDUJPO

0IN

0IN

 

'MBU5XJO

$PBYJBM

 

-FBE

$BCMF

 

 



 

 





 

 

 

0QUJPOBM0IN

 

 

UP0IN

 

 

.BUDIJOH5SBOTGPSNFS

 

Figure 3. Connecting a Single Antenna

Antennas with Separate UHF and VHF Leads

Figure 4

A UHF/VHF combiner is required. This is not included with the TV.

1.Connect the UHF and VHF antenna leads to the UHF/ VHF combiner.

2.Push the combiner onto ANT-1 MAIN on the TV back panel.

7)'"OUFOOB

6)'"OUFOOB

 

$IBOOFMT

$IBOOFMT

 

'MBU5XJO-FBE

'MBU5XJO-FBE

&YUFSOBM

 

 

57CBDLQBOFMTFDUJPO

"OUFOOB

 

 

PS$BCMF

 

 

 

 

0INUP

 

 

0IN

 

 

$PNCJOFS



 

6)'

 

 

 

 

 

7)'

 

 

 

#BDL

4JEF

 

 

7JFX

7JFX

 

 



4OO!.4!-!).

 

 

Figure 4. Connecting separate UHF and VHF Antennas

Mitsubishi strongly recommends you avoid using antennas with flat twin leads. Flat twin lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

Chapter 2. Connecting

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Owner’s Guide Lamp Replacement TV Guide On Screen Access RequirementsWhile Under Warranty After Warranty Stand RequirementFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksTV Accessories Special Features Front Control Panel Remote Control      TV AccessoriesSpecial Features Reset System ResetFront-Panel Indicator Lights Power/Timer IndicatorLamp Indicator Status IndicatorOverview Remote ControlSleep Timer Battery InstallationCare TV Back Panel IR Emitter NetCommandInput 1 Component 1, 2, and 3 InputsDTV Link/IEEE Hdmi 1CableCARD Slot Digital Audio OutputMedia Card Slots Media Card Slots and Front-Panel InputsFront-Panel Input Card CompatibilityUsing the System Reset Button Demo ModeUsing the Reset Menu to Reset Additional InformationPage Connecting Stereo and/or digital audio cables AV Receiver Connecting External Devices and NetCommand SetupCableCARD Technology Using a CableCARDCableCARD Technology Wall Outlet Cable Connecting a Wall Outlet Cable or Cable BoxStandard Cable Box Antennas with Separate UHF and VHF Leads Antenna with a Single LeadFor antennas with flat twin leads For cable or antenna with coaxial lead$BCMF VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoSatellite Receiver or Other Device with S-Video Receiver Stereo SystemTo connect an analog A/V receiver DVI Device DVD Player with Component VideoHdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoComputer with an Hdmi Monitor Output Connecting a Computer with an Hdmi or DVI Monitor OutputComputer with a DVI Monitor Output An IR emitter cable is included with the TV Connecting the IR Emitter NetCommandWhen Connecting Ieee 1394 Devices Connecting Compatible Ieee 1394 DevicesCompatible Ieee 1394 Devices Connection Styles Pin Style vs -Pin Style ConnectorsDirect Device-To-Device Style Hub Connection StyleHelpful Hints Page NetCommand Setup and Editing Welcome To NetCommand NetCommand IntroductionNetCommand Pre-Memorized Devices Using the Remote Control with NetCommandNetCommand Setup On-Screen Buttons 3D Graphical Remote Control ButtonsNetCommand Information Screen NetCommand Initial SetupSetup Reminder Welcome ScreenDevice Setup Screen Finish Screen Review ScreenReceiver Screen Edit NetCommand Add an A/V ReceiverReceiver Inputs Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenEdit NetCommand Screen Edit NetCommand Add DevicesAdd Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenRF Connection for Cable Screen VCR for Recordings ScreenIR Code for Device Screen Change Device Screen Edit NetCommand Change or Delete DevicesDelete Device Screen Ieee 1394 Devices and NetCommand- Controlled Recordings Ieee 1394 Devices and NetCommand Control Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyName for 1394 Device Screen New 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenDevice Selection Menu Power On/Off DevicesPIP Device Selection Menu Device Menu Using the Device Menu Button to Display MenusIR Controlled Devices Moving Through Other CableCARD ScreensGuide Button Using the Guide Button to Display ChannelView and MenusGuide and the Device Selection Menu Guide and the Record To MenuSetting up Recordings NetCommand-Controlled RecordingsTime-Delayed Recording Recording NowRecord List, Peer-to-Peer Connections Using A/V Discs Using A/V DiscsDirect VCR Recording from an Antenna or Cable Source Copy-Protected MaterialTV Menu Screen Operations Main Menu Language Setup MenuMemorize Channels ClockDate Timer On/OffTime Zone Daylight Savings TimeRemote Control Transport Buttons NetCommand MenuEdit Transport MenuTime-Delayed Recording Recording SetupRecord Menu RecordSetting Up Analog Recordings with TV Guide On Screen Default Digital Record DeviceCancel Current Recordings Analog RecordingsAntenna Channel MenuPrefer Digital MemorySQV SuperQuickView Signal StrengthCaptions Menu Digital SettingsAnalog Captions BackgroundSize FontsColor Opacity FontChip Chip Lock MenuEntry Chip Start Time and V-Chip Stop TimeContent Categories Chip Signal InformationPrograms without V-Chip signals Chip Lock Menu V-Chip DefinitionsFront Button Lock Lock By TimeAudio/Video Menu Analog and Digital Audio Settings Setting Descriptions AudioAnalog-Only Audio Settings Digital-Only Audio SettingsVideo Settings Setting Descriptions VideoHorizPosition Horizontal Position Auto PositionVertPosition Vertical Position Fine DetailMediaCommand and Media Card Playback Additional FeaturesOperation of PIP TV Display Formats Signal and Format DefinitionsDVD Definitions Anamorphic or Enhanced for Wide-Screen TV’s57%JTQMBZ PC Viewing PC resolution XGA selectionSignal Format Standard Zoom Signal Format 16 X 9 StandardPC Display Formats Inserting a media card MediaCommand and Media Card PlaybackDon’t pull the media card out while it is playing For MP3 or WMA Audio PlaybackMedia Command and Media Card Playback Troubleshooting Problem Possible Solution TroubleshootingThere is a large black or gray rectangle on Devices are grayed out in the Device Selection All Ieee 1394 devices disappear Troubleshooting Appendix B Specifications Appendix H Lamp Cartridge ReplacementAppendix G Cleaning and Service Appendix a Bypassing the V-Chip LockPage Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank TV Specifications Appendix B SpecificationsInputs Outputs Programming the Remote to Control NetCommand A/V Products Appendix C Remote Control Programming CodesDVD Players Cable/SAT/DTV position TV positionVCR position DVD positionNetCommand Compatible Traditional Devices Analog Appendix D Device Control with NetCommandIeee 1394 Devices When an Ieee 1394 Device is Viewed or PlayedAppendix E NetCommand Specialized Device Keys Analog Program Appendix F On-Screen Information DisplaysDigital Program Digital Ieee 1394 DeviceAppendix G Cleaning and Service Lamp Life Appendix H Lamp Cartridge ReplacementDo not touch the glass parts of the lamp cartridge Burn DangerTrademark and License Information Mitsubishi TV Software Index VCR 115 Mitsubishi DLP Projection Television Limited Warranty116 This Limited Warranty does not CoverPage Website Mail MDEAservice@mdea.com
Related manuals
Manual 86 pages 7.9 Kb
Top Page Image Contents