Mitsubishi Electronics WD-62627 Additional Information, Demo Mode, Using the System Reset Button

Page 19

Additional Information

Using the System Reset Button

If the TV doesn’t respond to either the remote control or the front panel controls or will not power off, press the SYSTEM RESET button on the front panel with a pointed item such as the point of a ball point pen or end tip of a paperclip.

The TV will turn off and the green LED will flash quickly for about one minute. When the green LED stops flashing, you may turn on the TV again. The changes you made while the TV was most recently on, before you used the SYSTEM RESET button may be lost; the changes you made previously, however, are not lost. Only those changes since the last power On may be lost when the system reset button is pressed. All other settings are retained.

Using the Reset Menu to Reset the

TV

Read on-screen warnings before proceeding, as some user data or settings may be erased.

1.Select any device from the Device Selection menu. Press TV MENU followed by 1,2,3 to see the RESET SERVICE MENU to reset the TV.

2.Select Reset System Defaults (CAUTION: All settings, except V-Chip, will be reset to the original factory defaults).

Demo Mode

This TV has a demo mode for use in retail stores. To turn the demo mode On/Off, press the following buttons in sequence:

MENU, 0, QV, 0

IMPORTANT

Do not attempt to update the software of this TV with software or cards that are not provided by or authorized by Mitsubishi Digital Electronics America, Inc. Non-authorized software may damage the TV and will not be covered by the warranty.

Chapter 1. Television Overview

19

Image 19
Contents Owner’s Guide Stand Requirement TV Guide On Screen Access RequirementsLamp Replacement While Under Warranty After WarrantyFCC Declaration of Conformity Important Safeguards Important Safeguards Contents Mitsubishi DLP Projection Television Limited Warranty Mitsubishi Digital Electronics America, Inc Our ThanksTV Accessories Special Features Front Control Panel Remote Control      TV AccessoriesSpecial Features Power/Timer Indicator System ResetReset Front-Panel Indicator LightsLamp Indicator Status IndicatorOverview Remote ControlSleep Timer Battery InstallationCare Component 1, 2, and 3 Inputs IR Emitter NetCommandTV Back Panel Input 1Digital Audio Output Hdmi 1DTV Link/IEEE CableCARD SlotCard Compatibility Media Card Slots and Front-Panel InputsMedia Card Slots Front-Panel InputAdditional Information Demo ModeUsing the System Reset Button Using the Reset Menu to ResetPage Connecting Stereo and/or digital audio cables AV Receiver Connecting External Devices and NetCommand SetupCableCARD Technology Using a CableCARDCableCARD Technology Wall Outlet Cable Connecting a Wall Outlet Cable or Cable BoxStandard Cable Box For cable or antenna with coaxial lead Antenna with a Single LeadAntennas with Separate UHF and VHF Leads For antennas with flat twin leads$BCMF VCR to an Antenna or Wall Outlet Cable Audio & VideoVCR to a Cable Box Audio & Video Connecting a VCR to a Cable Box Audio & VideoSatellite Receiver or Other Device with S-Video Receiver Stereo SystemTo connect an analog A/V receiver DVI Device DVD Player with Component VideoHdmi Device Hdtv Cable Box or Satellite Receiver with Component VideoComputer with an Hdmi Monitor Output Connecting a Computer with an Hdmi or DVI Monitor OutputComputer with a DVI Monitor Output An IR emitter cable is included with the TV Connecting the IR Emitter NetCommandWhen Connecting Ieee 1394 Devices Connecting Compatible Ieee 1394 DevicesCompatible Ieee 1394 Devices Hub Connection Style Pin Style vs -Pin Style ConnectorsConnection Styles Direct Device-To-Device StyleHelpful Hints Page NetCommand Setup and Editing Welcome To NetCommand NetCommand IntroductionNetCommand Pre-Memorized Devices Using the Remote Control with NetCommandNetCommand Setup On-Screen Buttons 3D Graphical Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Setup ReminderDevice Setup Screen Finish Screen Review ScreenReceiver Screen Edit NetCommand Add an A/V ReceiverReceiver Inputs Receiver AVR Learn Screen Receiver AVR Input Learn ScreenAudio Output to AVR Screen Name ScreenEdit NetCommand Screen Edit NetCommand Add DevicesAdd Screen Device Learn Screen Device ScreenConnection for Device Screen Device Advanced Learn ScreenRF Connection for Cable Screen VCR for Recordings ScreenIR Code for Device Screen Change Device Screen Edit NetCommand Change or Delete DevicesDelete Device Screen Ieee 1394 Devices and NetCommand- Controlled Recordings Ieee 1394 Devices and NetCommand Control New 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically Name for 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenDevice Selection Menu Power On/Off DevicesPIP Device Selection Menu Moving Through Other CableCARD Screens Using the Device Menu Button to Display MenusDevice Menu IR Controlled DevicesGuide and the Record To Menu Using the Guide Button to Display ChannelView and MenusGuide Button Guide and the Device Selection MenuRecording Now NetCommand-Controlled RecordingsSetting up Recordings Time-Delayed RecordingRecord List, Peer-to-Peer Connections Copy-Protected Material Using A/V DiscsUsing A/V Discs Direct VCR Recording from an Antenna or Cable SourceTV Menu Screen Operations Main Menu Clock Setup MenuLanguage Memorize ChannelsDaylight Savings Time Timer On/OffDate Time ZoneTransport Menu NetCommand MenuRemote Control Transport Buttons EditRecord Recording SetupTime-Delayed Recording Record MenuAnalog Recordings Default Digital Record DeviceSetting Up Analog Recordings with TV Guide On Screen Cancel Current RecordingsMemory Channel MenuAntenna Prefer DigitalSQV SuperQuickView Signal StrengthBackground Digital SettingsCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Start Time and V-Chip Stop Time Chip Lock MenuChip EntryChip Lock Menu V-Chip Definitions Chip Signal InformationContent Categories Programs without V-Chip signalsFront Button Lock Lock By TimeAudio/Video Menu Digital-Only Audio Settings Setting Descriptions AudioAnalog and Digital Audio Settings Analog-Only Audio SettingsVideo Settings Setting Descriptions VideoFine Detail Auto PositionHorizPosition Horizontal Position VertPosition Vertical PositionMediaCommand and Media Card Playback Additional FeaturesOperation of PIP Anamorphic or Enhanced for Wide-Screen TV’s Signal and Format DefinitionsTV Display Formats DVD Definitions57%JTQMBZ PC Viewing PC resolution XGA selectionSignal Format Standard Zoom Signal Format 16 X 9 StandardPC Display Formats For MP3 or WMA Audio Playback MediaCommand and Media Card PlaybackInserting a media card Don’t pull the media card out while it is playingMedia Command and Media Card Playback Troubleshooting Problem Possible Solution TroubleshootingThere is a large black or gray rectangle on Devices are grayed out in the Device Selection All Ieee 1394 devices disappear Troubleshooting Appendix a Bypassing the V-Chip Lock Appendix H Lamp Cartridge ReplacementAppendix B Specifications Appendix G Cleaning and ServicePage Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank TV Specifications Appendix B SpecificationsInputs Outputs Programming the Remote to Control NetCommand A/V Products Appendix C Remote Control Programming CodesDVD Players DVD position TV positionCable/SAT/DTV position VCR positionNetCommand Compatible Traditional Devices Analog Appendix D Device Control with NetCommandIeee 1394 Devices When an Ieee 1394 Device is Viewed or PlayedAppendix E NetCommand Specialized Device Keys Digital Ieee 1394 Device Appendix F On-Screen Information DisplaysAnalog Program Digital ProgramAppendix G Cleaning and Service Lamp Life Appendix H Lamp Cartridge ReplacementDo not touch the glass parts of the lamp cartridge Burn DangerTrademark and License Information Mitsubishi TV Software Index VCR 115 Mitsubishi DLP Projection Television Limited Warranty116 This Limited Warranty does not CoverPage Website Mail MDEAservice@mdea.com
Related manuals
Manual 86 pages 7.9 Kb