Mitsubishi Electronics WD-52627, WD-62627 manual Using A/V Discs, Copy-Protected Material

Using A/V Discs

Direct VCR Recording from an Antenna or Cable Source Copy-Protected Material and Restrictions for Traditional VCRs

Using A/V Discs

A/V Disc Search

NetCommand is able to search to a specific time in a recording on an IEEE 1394 A/V Disc.

1.Start the desired track’s playback on the A/V disc.

2.Use the number buttons to enter the time code position of hours followed by minutes. For example, to enter one hour and twenty-two minutes (1:22) into the track, enter 1, 2, 2.

3.Press ENTER to skip to the time code position.

4.To cancel the request or to start over, press CANCEL instead of ENTER.

Track List Screen

Figure 15

When viewing an A/V Disc, press GUIDE to display its Track List. The time and date it was added, the duration and title will be displayed. Tracks will be listed in date and time order and will vary in size. Press ADJUST or to navigate through the Track List. To play a track, select it on the list, then press ENTER. To change pages, press CH or . To delete a track, select it on the list and press CANCEL.

Figure 15. Track List screen

Using the Remote Control with an A/V Disc after selecting from the Device Selection menu:

GUIDE:	displays the Track List of recorded programs.
PLAY:	resumes playback of paused program.
PAUSE:	pauses or resumes playback of program.
FF/FWD:	forward picture search, multiple presses increase
	the speed.
REW/REV:	reverse picture search, multiple presses increase
	the speed.
ADJUST	: skip backward 12 seconds per press.
ADJUST	: skip forward 30 seconds per press.
ADJUST	: skip to the end of the track.
ADJUST	: skip to the beginning of the track.
REC:	Display the Record Menu to schedule recordings

Direct VCR Recording from an Antenna or Cable Source:

When your VCR is the recording device, pressing REC (record) on the TV’s remote control will function the same way as pressing the record button on the VCR’s remote control or front panel.

To record directly from antenna or cable:

1.Press DEVICE on the TV’s remote to display the Device Selection menu. Highlight the traditional VCR and press POWER to turn on the VCR. If necessary, press GUIDE to select the input the VCR is on, such as Antenna input (or line input).

2.Press ENTER to switch the TV to the VCR.

3.Select the correct channel for recording on the VCR and then press REC to start recording. You will need to manually stop the recording at the end of the program

OR...

With the VCR as the selected recording device, press the DEVICE MENU button to display the VCR’s menu, in which you can schedule a delayed recording directly from antenna or cable.

To record from ANT-1, ANT-2 or other devices, see NetCommand Controlled Recordings or refer to the TV Guide On Screen® User’s Guide.

Copy-Protected Material

When attempting to record copy-protected material, the Record functions of the NetCommand and IEEE 1394 systems may be prevented or stopped. If you have a recording that is tagged “Record Once”, NetCommand will change the tag to “Record No More.”

Restrictions for Traditional VCRs

•Your VCR should be connected directly to the RECORD/OUT and VIDEO outputs.

•The VCR must be set manually to “Line Input.” Display the Device Selection menu, highlight the VCR and press GUIDE to change VCR inputs.

•If NetCommand is set up, the TV can select channels on compatible cable boxes for recordings. Leave the cable box turned on.

•If the source device or recording device does not have separate power On and Off features, then leave that device powered On.

•You cannot record from source devices connected to the TV Component 1–3 or HDMI 1 or 2 connections.

62 Chapter 4. IEEE 1394 Devices and NetCommand-Controlled Recordings