Mitsubishi Electronics WS-55615, WS-65515A Connecting External Devices & NetCommand Setup, Chart

Page 14

Connecting External Devices & NetCommand® Setup

NetCommand is able to control many current audio and video devices by sending remote control signals from the TV to each device through IR emitters. Additionally, it is able to learn the remote control signals used by most audio video devices not already in the TV’s memory. NetCommand can automatically switch the TV along with compatible or learned Audio/Video (A/V) Receivers to the correct input for use with each device. It is important that the inputs on the TV and A/V Receiver back panel match the NetCommand setup that is displayed on-screen.

To simplify the installation of NetCommand, there is a step-by-step on-screen NetCommand setup procedure in this chapter, which details the type and brand of devices you are connecting to the TV. The NetCommand Setup also assigns preset TV and A/V Receiver inputs for each device. You should connect each device to the TV input (both audio and video) and to the A/V Receiver (audio) as shown in the figure below.

Device to be

video and stereo connected audio cables

IR Emitters

stereo and/or digital audio cables

TV

stereo and digital audio cables

AV Receiver

The following charts show which preset inputs you should use on the TV and A/V Receiver. Chart 1 shows TV inputs.

Chart 2 shows the A/V Receiver inputs used by A/V Receiver models already known by NetCommand.

Chart 1

Device Audio and Video Outputs to TV Inputs

Cable for CableCARD™ Service

ANT-1

 

 

Antenna/Cable (digital/analog)

ANT-1 if primary viewing source,

 

ANT-2 if secondary viewing source

 

 

Cable box

ANT-2

 

 

VCR

Input-1

 

 

Satellite Receiver (DBS)

Input-2

 

 

Camcorder

Input-3 (on front panel)

 

 

DVD Player

Component-1

 

 

Chart 2

Mitsubishi 1

Mitsubishi 2

Bose

 

Denon

Integra

Kenwood

Marantz

Pioneer 1

Pioneer 2

Rotel

Sony

Yamaha 1

Yamaha 2

 

Model

Model

Model

 

Model

Model

Model

Model

Model

Model

Model

Model

Model

Model

 

 

 

 

M-VR800 &

M-VR900 &

Lifestyle ®28

 

AVR-2700

DTR-9.1

VR-2080

SR8200

VSX-D557

VSX-49TX

RSX-1065

STR-DE825

RV-X2095

RX-V2200

 

M-VR1000

M-VR700

 

 

 

 

 

 

 

 

 

 

 

 

Device Audio Output

to

AV Receiver Inputs by Name

 

 

 

 

 

 

 

 

 

 

VCR

 

VCR 1

VCR

VCR

 

VCR-1

Video 1

Video 1

VCR1

VCR/Tape

VCR 1/DVR

Video 2

Video 1

VCR 1

VCR 1

Satellite Receiver

 

Aux

Cable/DBS

AUX

 

CD

Video 3

Video 3

DSS

CD

SAT

Video 4

TV/DBS

TV/DBS

D-TV/LD

DVD Player

 

DVD

DVD

(built-in)

 

DVDVDP

DVD

Video 4

DVD

LD/SAT

DVD/LD

Video 5

TAPE/MD

CD

DVD

TV Monitor Output

 

TV

TV

TV

 

TV/DBS

Video 4

Video 4

TV

DVD/TV

TV

Video 1

DVD/LD

DVD/LD

CBL/SAT

(& Digital Audio)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

After using NetCommand Setup, you may go to the NetCommand menu (see “Edit NetCommand”) at any time to change the inputs you used for connecting each device, custom name devices, add devices not included in the presets above or delete devices no longer used. See Connection Helpful Hints, at the end of this chapter for additional information on device setup.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Important Safeguards Important SAFEGUARDS, cont’d Our Thanks Mitsubishi Digital Electronics America, IncChapter Television OverviewTV Accessories Special FeaturesPOWER/TIMER Indicator Front Control PanelDigital Audio Output Back PanelIEEE-1394 Input/Output CableCARD SlotDVI Analog Audio IR Output-NetCommandHdmi or DVI Devices Component InputsNews and stock-market report bars Letterbox top/bottom black barsSide bar images Shopping channel logos & pricing displaysConnecting Connecting External Devices & NetCommand Setup ChartConnecting a Wall Outlet Cable or Cable Box Cable Box compatible with PIP/POPFor antennas with twin flat lead Single AntennaSeparate UHF and VHF Antennas For antennas with coaxial leadVCR to Antenna or Wall Outlet Cable RedConnecting VCR Video and Audio to a Cable Box VCR to a Cable BoxReceiver or Stereo System Satellite Receiver or Other Device with S-VideoDVI Device Connecting a DVD Player with Component Video or DVI DeviceDVD Player with Component Video Hdmi Device External DTV Receiver with Component VideoConnecting the IR Emitter NetCommand IR Emitter NetCommandConnecting Ieee 1394 Devices Pin Style vs -Pin StyleDirect Device-To-Device Style Ieee 1394 Device Connection StylesConnection Styles Hub Connection StyleCableCARD Technology Using a CableCARDCableCARD Definition and Initial Screen Display Connecting Helpful Hints NetCommand Setup and Editing NetCommand Pre-Memorized Devices DeviceRemote Control Functions Overview FollowingOperation Remote Control FunctionsOperation, Care, Sleep TimerSleep Timer CareNetCommand On-Screen Buttons Remote Control Buttons 3D Graphical Menu SystemDevice Setup Screen NetCommand Initial SetupNetCommand Information Screen Welcome ScreenReview Screen Finish ScreenReceiver Inputs Edit NetCommand, Adding an A/V ReceiverReceiver Screen Receiver Input Learn Screen Receiver Learn ScreenName Screen Monitor Out to AVR ScreenEdit NetCommand, Adding Devices Edit NetCommandAdd Screen Device ScreenDevice Learn Screen Device Advanced Learn ScreenRF Connection for Cable Screen Connection for Device ScreenVCR for Recordings Screen IR Code for Device ScreenChange Screen Delete ScreenDevice Selection Menu IR Controlled Devices/IEEE 1394 Menus Using the Device Menu Button to Display MenusDevice Menu CableCARD MenuIeee 1394 Devices and NetCommand Controlled Recordings New 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically Name for 1394 Device ScreenIeee 1394 Device Type Screen Connection ScreenDigital Control Signal Digital Video SignalsDigital Audio Signals Ieee 1394 Devices CompatibilityUsing the Guide Button to Display ChannelView and Menus Time-Delayed Recording NetCommand Controlled RecordingsRecord To Setup Recording NowDisc Search Cancel Current RecordingsRecord List Screen Track List ScreenRestrictions for Traditional VCRs Direct VCR RecordingDirect VCR Recording from an Antenna or Cable Source Setting up a Peer-to-Peer Connection NetCommand Controlled Peer-to-Peer ConnectionsWhat is a Peer-to-Peer Connection? Canceling a Current Peer-to-Peer ConnectionImportant Notes TV Menu Screen Operations Main Menu Choices Setup Menu Reset Factory Defaults Menu Advanced ConvergenceNetCommand Menu Antenna Menu SQV SuperQuickView Time Menu Setting the ClockTimer On/Off ManualAnalog Captions Captions MenuCaptions Menu Digital CaptionsColor FontsSize Opacity FontEntry Chip Lock MenuChip Chip Start Time and V-Chip Stop TimeTV Ratings Chip Signal InformationContent Categories Lock By Time Front Button LockAudioVideo Menu AudioVideoAnalog Only Audio Settings Setting DescriptionsAnalog and Digital Audio Setting Digital Only Audio SettingsVideo Settings ContrastChapter Format Definitions Format SignalsDisplay Formats DVD DefinitionsOriginal Signal Operation of PIP and POP Changing PIP/POP DeviceDevice Menu with Net Command Ieee 1394 Devices Digital Bypassing Front Button Lock Appendix a Bypassing the V-Chip LockBypassing the V-Chip Lock This page intentionally blank Component-1 and Component-2 Inputs Input Levels and Timing with Component Video SignalsAppendix B High Definition Input Connection Compatibility Appendix CRemote Control Programming Codes Programming the Remote to Control NetCommand A/V ProductsAppendix C Remote Control Programming Codes DVD PlayersMitsubishi A/V Receivers Cable Boxes and Satellite ReceiversReceivers Mitsubishi CD Players Not all functions for all modelsAppendix D On Screen Information Displays Appendix E NetCommand Specialized Device Keys Checkbox NameAppendix F Cleaning and Service For the WS-55515, WS-65515 and WS-65515A Appendix G Diamond Shield Removal for ModelsFor the WS-48515 For additional assistance, call 800For the WS-55615, WS-55615A, WS-65615 and WS-65615A Appendix G, Diamond Shield Installation for Model WS-73615 Appendix H Cabinet Separation for Models WS-65515, WS-65515A, WS-65615, WS-65615A, WS-73615Troubleshooting Problem Possible SolutionTroubleshooting Troubleshooting Using The System Reset Button Demo Mode Additional InformationIndex Menu 56 Mitsubishi Projection TV Limited Warranty Mitsubishi Projection Television Limited WarrantyMitsubishi TV Software Page Mitsubishi Digital Electronics America, Inc D405A10

WS-48515, WS-55615A, WS-55615, WS-73615, WS-65515A specifications

The Mitsubishi Electronics WS series of rear-projection televisions, specifically models WS-65615, WS-65515, WS-65615A, WS-55515, and WS-65515A, represent a significant era in home entertainment technology. Known for their innovative features and exceptional image quality, these models were well-regarded for both functional performance and design.

One of the most notable characteristics of the WS series is their use of DLP (Digital Light Processing) technology. This allows for sharper images and more vibrant colors compared to traditional CRT televisions. DLP technology also reduces issues like pixelation, offering a smoother image overall. The WS-65615 and WS-65615A feature a large 65-inch screen, delivering an immersive viewing experience perfect for movie nights and gaming. Meanwhile, the WS-65515 and WS-65515A provide a slightly smaller 55-inch display, which still offers remarkable visuals without taking up as much space.

All models are equipped with a High-Definition Multimedia Interface (HDMI) input, ensuring compatibility with modern devices like Blu-ray players, gaming consoles, and streaming devices. This connectivity is crucial for those looking to enhance their entertainment systems with the latest technology. Additionally, the WS series supports various audio-video formats, giving users flexibility in how they enjoy their content.

Another key feature is the incorporation of a 3D-ready capability, making these TVs future-proof for a time when 3D content was gaining traction. This aspect attracted cinema enthusiasts who wanted to bring an enhanced experience home. The models also include a built-in digital tuner, allowing users to access over-the-air broadcasts without needing an external box.

The WS-65615 and WS-65515 models additionally boast a stylish and slim design that fits well within modern living spaces, combining aesthetics with functionality. Their lightweight construction allows for easier installation and setup.

Overall, the Mitsubishi Electronics WS-65615, WS-65515, WS-65615A, WS-55515, and WS-65515A televisions deliver a compelling mix of advanced technologies, user-friendly features, and stunning visuals. While they may be considered legacy models today, they still exemplify the quality and innovation Mitsubishi Electronics strived for in enhancing the home viewing experience.
Top Page Image Contents