Mitsubishi Electronics WS-55615A, WS-65515A, WS-65615A Appendix CRemote Control Programming Codes

IMPORTANT

The remote control may return to its initial setting when the batteries are changed. You may need to reprogram.

Programming the Remote to Control NetCommand A/V Products

1.Move the slide switch at the top of the remote to the TV position.

2.Press and hold POWER on the remote control.

3.Enter the three digit code of 935, and then release

POWER.

4.When the remote control is in the TV position, it is now programmed to send NetCommand signals to the TV so the TV can control the IEEE 1394 devices and older NetCommand supported or learned IR devices,

Note: To put the remote in the ”Legacy Mode” configuration, repeat Steps 1 and 2. At Step 3, enter the code 000 and release POWER. This also returns volume and mute control to the TV from the A/V Receiver.

A/V Receivers

Programming the Remote to Control Other Brands of Audio and Video Products

1.Move the slide switch at the top of the remote to the product you want to control.

2.Press and hold POWER on the remote control.

3.Enter the first three digit code listed for your equipment, and then release the POWER button on the remote control.

4.Point the remote control at the equipment and press the POWER button. If the equipment responds, the remote control is properly programmed to operate the equipment. If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3 for your equipment.

Cable Boxes