Mitsubishi Electronics WS-55615, WS-65515A, WS-65615A, WS-73615 manual Important SAFEGUARDS, cont’d

Page 5

IMPORTANT SAFEGUARDS, cont’d.

12.Power Lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

13.Overloading

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

14.Object and Liquid Entry

Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock. Never spill liquid of any kind on or into the TV.

15.Outdoor Antenna Grounding

If an outside antenna or cable system is connected to the TV, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.

Article 810 of the National Electric Code, ANSI/NFPA No. 70-2002, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

16. Servicing

EXAMPLE OF ANTENNA GROUNDING

 

ANTENNA

 

LEAD IN WIRE

GROUND CLAMP

 

 

ANTENNA

 

DISCHARGE UNIT

ELECTRIC

(NEC SECTION 810-20)

 

SERVICE

GROUNDING

EQUIPMENT

CONDUCTORS

 

 

(NEC SECTION 810-21)

 

GROUND CLAMPS

 

POWER SERVICE GROUNDING

 

ELECTRODE SYSTEM

NEC — NATIONAL ELECTRICAL CODE (NEC ART 250, PART H)

Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

17. Damage Requiring Service

Unplug the TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:

(a)When the power-supply cord or plug is damaged.

(b)If liquid has been spilled, or objects have fallen into the TV.

(c)If the TV has been exposed to rain or water.

(d)If the TV does not operate normally by following the operating instructions, adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the TV to its normal operation.

(e)If the TV has been dropped or the cabinet has been damaged.

(f)When the TV exhibits a distinct change in performance - this indicates a need for service.

18.Replacement Parts

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards.

19.Safety Check

Upon completion of any service or repair to the TV, ask the service technician to perform safety checks to determine that the TV is in safe operating condition.

20.Heat

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

5

Image 5
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Important Safeguards Important SAFEGUARDS, cont’d Mitsubishi Digital Electronics America, Inc Our ThanksTelevision Overview ChapterSpecial Features TV AccessoriesFront Control Panel POWER/TIMER IndicatorIEEE-1394 Input/Output Back PanelDigital Audio Output CableCARD SlotHdmi or DVI Devices IR Output-NetCommandDVI Analog Audio Component InputsSide bar images Letterbox top/bottom black barsNews and stock-market report bars Shopping channel logos & pricing displaysConnecting Chart Connecting External Devices & NetCommand SetupCable Box compatible with PIP/POP Connecting a Wall Outlet Cable or Cable BoxSeparate UHF and VHF Antennas Single AntennaFor antennas with twin flat lead For antennas with coaxial leadRed VCR to Antenna or Wall Outlet CableVCR to a Cable Box Connecting VCR Video and Audio to a Cable BoxSatellite Receiver or Other Device with S-Video Receiver or Stereo SystemDVI Device Connecting a DVD Player with Component Video or DVI DeviceDVD Player with Component Video External DTV Receiver with Component Video Hdmi DeviceIR Emitter NetCommand Connecting the IR Emitter NetCommandPin Style vs -Pin Style Connecting Ieee 1394 DevicesConnection Styles Ieee 1394 Device Connection StylesDirect Device-To-Device Style Hub Connection StyleCableCARD Technology Using a CableCARDCableCARD Definition and Initial Screen Display Connecting Helpful Hints NetCommand Setup and Editing Device NetCommand Pre-Memorized DevicesFollowing Remote Control Functions OverviewSleep Timer Remote Control FunctionsOperation, Care, Sleep TimerOperation CareNetCommand On-Screen Buttons 3D Graphical Menu System Remote Control ButtonsNetCommand Information Screen NetCommand Initial SetupDevice Setup Screen Welcome ScreenFinish Screen Review ScreenReceiver Inputs Edit NetCommand, Adding an A/V ReceiverReceiver Screen Receiver Learn Screen Receiver Input Learn ScreenMonitor Out to AVR Screen Name ScreenEdit NetCommand Edit NetCommand, Adding DevicesDevice Screen Add ScreenDevice Advanced Learn Screen Device Learn ScreenVCR for Recordings Screen Connection for Device ScreenRF Connection for Cable Screen IR Code for Device ScreenDelete Screen Change ScreenDevice Selection Menu Device Menu Using the Device Menu Button to Display MenusIR Controlled Devices/IEEE 1394 Menus CableCARD MenuIeee 1394 Devices and NetCommand Controlled Recordings Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenDigital Audio Signals Digital Video SignalsDigital Control Signal Ieee 1394 Devices CompatibilityUsing the Guide Button to Display ChannelView and Menus Record To Setup NetCommand Controlled RecordingsTime-Delayed Recording Recording NowRecord List Screen Cancel Current RecordingsDisc Search Track List ScreenRestrictions for Traditional VCRs Direct VCR RecordingDirect VCR Recording from an Antenna or Cable Source What is a Peer-to-Peer Connection? NetCommand Controlled Peer-to-Peer ConnectionsSetting up a Peer-to-Peer Connection Canceling a Current Peer-to-Peer ConnectionImportant Notes TV Menu Screen Operations Main Menu Choices Setup Menu Advanced Convergence Reset Factory Defaults MenuNetCommand Menu Antenna Menu SQV SuperQuickView Timer On/Off Setting the ClockTime Menu ManualCaptions Menu Captions MenuAnalog Captions Digital CaptionsSize FontsColor Opacity FontChip Chip Lock MenuEntry Chip Start Time and V-Chip Stop TimeTV Ratings Chip Signal InformationContent Categories Front Button Lock Lock By TimeAudioVideo AudioVideo MenuAnalog and Digital Audio Setting Setting DescriptionsAnalog Only Audio Settings Digital Only Audio SettingsContrast Video SettingsChapter Display Formats Format SignalsFormat Definitions DVD DefinitionsOriginal Signal Changing PIP/POP Device Operation of PIP and POPDevice Menu with Net Command Ieee 1394 Devices Digital Bypassing Front Button Lock Appendix a Bypassing the V-Chip LockBypassing the V-Chip Lock This page intentionally blank Component-1 and Component-2 Inputs Input Levels and Timing with Component Video SignalsAppendix B High Definition Input Connection Compatibility Programming the Remote to Control NetCommand A/V Products Appendix CRemote Control Programming CodesDVD Players Appendix C Remote Control Programming CodesReceivers Cable Boxes and Satellite ReceiversMitsubishi A/V Receivers Mitsubishi CD Players Not all functions for all modelsAppendix D On Screen Information Displays Checkbox Name Appendix E NetCommand Specialized Device KeysAppendix F Cleaning and Service For the WS-48515 Appendix G Diamond Shield Removal for ModelsFor the WS-55515, WS-65515 and WS-65515A For additional assistance, call 800For the WS-55615, WS-55615A, WS-65615 and WS-65615A Appendix G, Diamond Shield Installation for Model WS-73615 WS-65515, WS-65515A, WS-65615, WS-65615A, WS-73615 Appendix H Cabinet Separation for ModelsProblem Possible Solution TroubleshootingTroubleshooting Troubleshooting Using The System Reset Button Additional Information Demo ModeIndex Menu 56 Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Page Mitsubishi Digital Electronics America, Inc D405A10

WS-48515, WS-55615A, WS-55615, WS-73615, WS-65515A specifications

The Mitsubishi Electronics WS series of rear-projection televisions, specifically models WS-65615, WS-65515, WS-65615A, WS-55515, and WS-65515A, represent a significant era in home entertainment technology. Known for their innovative features and exceptional image quality, these models were well-regarded for both functional performance and design.

One of the most notable characteristics of the WS series is their use of DLP (Digital Light Processing) technology. This allows for sharper images and more vibrant colors compared to traditional CRT televisions. DLP technology also reduces issues like pixelation, offering a smoother image overall. The WS-65615 and WS-65615A feature a large 65-inch screen, delivering an immersive viewing experience perfect for movie nights and gaming. Meanwhile, the WS-65515 and WS-65515A provide a slightly smaller 55-inch display, which still offers remarkable visuals without taking up as much space.

All models are equipped with a High-Definition Multimedia Interface (HDMI) input, ensuring compatibility with modern devices like Blu-ray players, gaming consoles, and streaming devices. This connectivity is crucial for those looking to enhance their entertainment systems with the latest technology. Additionally, the WS series supports various audio-video formats, giving users flexibility in how they enjoy their content.

Another key feature is the incorporation of a 3D-ready capability, making these TVs future-proof for a time when 3D content was gaining traction. This aspect attracted cinema enthusiasts who wanted to bring an enhanced experience home. The models also include a built-in digital tuner, allowing users to access over-the-air broadcasts without needing an external box.

The WS-65615 and WS-65515 models additionally boast a stylish and slim design that fits well within modern living spaces, combining aesthetics with functionality. Their lightweight construction allows for easier installation and setup.

Overall, the Mitsubishi Electronics WS-65615, WS-65515, WS-65615A, WS-55515, and WS-65515A televisions deliver a compelling mix of advanced technologies, user-friendly features, and stunning visuals. While they may be considered legacy models today, they still exemplify the quality and innovation Mitsubishi Electronics strived for in enhancing the home viewing experience.