JVC AV-61S902 manual Auto Tuner Setup, Start

AV-61S902(E) 1/12/01 3:23 PM Page 29

Plug In Menu

AUTO TUNER SETUP

The AUTO TUNER SETUP feature automatically scans through all the channels your television can receive and memorizes only the channels with clear, active signals. This means when you scan through the channels, you will receive only channels with good signals, no more annoying static or dead air.

The AV-61S902 has two RF signal inputs with can be setup independent of each other. For example, you can set one input up to receive signals from an antenna and the other to receive signals from a satellite dish.

To run AUTO TUNER SETUP, use the 5° arrows to move to the AUTO TUNER SETUP option in the PLUG IN MENU. Select the option by pressing 2 or 3.

AUTO TUNER SETUP
INPUT - A	:	CABLE
INPUT - B	:	AIR

START

AUTO TUNER SETUP

The AUTO TUNER SETUP menu will now appear. Use the 2 3arrows to select antenna or cable as the sig- nal source for INPUT-A (see pages 12 to 14 for information on connecting to an antenna or cable). Use the 5

°arrows to move to INPUT-B if you wish to set up INPUT-B as well, or to START to begin AUTO TUNER SETUP. If you select INPUT-B, use the 2 3arrows to select antenna or cable as the signal source and then move to START. Press 2 or 3to begin AUTO TUNER SETUP.

NOW

PROGRAMMING !

A 48

The television will now scan through all the channels it can receive, memorizing those with clear, active sig- nals. AUTO TUNER SETUP will program INPUT-A and then INPUT-B if you have selected it also. Programming will take several minutes. When it is finished the following message will appear:

PROGRAMMING OVER!

You may add or delete channels from the Auto Tuner scan. If there are channels you do not wish to receive or if the Auto Tuner missed a channel which may have not been broadcasting or had a weak signal, you can modify the scan using the CHANNEL SUMMARY feature. For information on CHANNEL SUMMARY, see page 32.

29