Appendix B
Warning Messages
If the lamp replacement was successful, the television will operate normally. If there was a problem with the instal- lation, one of several messages may display on the front panel LED lights.
Lamp installed on a slant or not fully inside the television.
If the lamp unit has been installed into the unit slanted (not flat) or is not fully inserted into the lamp housing inside the television, when the television is turned on the ON TIMER and POWER light will be flash. The 10 LEDs will light, then turn off one each five seconds. When all LEDs are off, the television still will not display a picture.
To correct: Reinstall the new lamp unit. Repeat the lamp installation steps, taking care to observe all warnings. Make sure when the lamp unit is reinstalled, it is inserted into the unit so it sits FLAT inside the unit.
If the ON TIMER light or POWER light is flashing you need to reset the television. Reset the television by unplug- ging the power cord from the AC outlet and then plugging the cord back into the outlet.
Filter not properly reinstalled.
If the filter unit has not been correctly reinstalled or if the filter has been damaged, the television will not turn on. When the Power button is pressed the 10 LEDs will turn on, then one will turn off every five seconds. When three have turned off the television will then enter a
To correct: Check to see that the filter has been installed properly. Repeat steps 1 to 5 and 8 to 10. You do not need to remove and reinstall the lamp. If the television still does not turn on, the filter may have been damaged. Call a service technician for repair.
If the television does not work properly, or displays a message not listed here, call a technician for service.
Recycling Information
| Save the box and packaging from your replacement lamp. |
| You can use this packaging to return your used projection |
| lamp for recycling. Please do not throw the used lamp out |
| with normal trash. A |
| purpose. To package your used lamp for shipment, follow |
1. | the simple steps below. |
2.
1)Collect the box and packaging from the replacement lamp. Make sure the used projection lamp has fully cooled
before packaging.
2) Carefully wrap the used lamp in the bag which contained the new projection lamp. Close and secure the bag.
3) Place the bag with the lamp inside the box with the original packaging material. Close and seal the box with packing tape.
4)Remove the old shipping label. Place the new
The lamp assembly in this product contains mercury. Disposal of the lamp assembly may be regulated due to environmental considerations. For information on replacement, disposal or recycling procedures, please contact JVC Customer Relations at
3.
4.
63