BenQ MP620p user manual Safety Instructions

Page 10

Safety Instructions (Continued)

10.Do not step on the projector or place any objects upon it. Besides probable physical damage to the projector, doing so may result in accidents and possible injury.

11.Do not block the projection lens with any objects when the projector is under operation as this could cause the objects to become heated and deformed or even cause a fire. To temporarily turn off the lamp, press Blank on the projector or remote control.

12.Do not place liquids near or on the projector. Liquids spilled into the projector may cause it to fail. If the projector does become wet, disconnect it from the power supply’s wall socket and call BenQ to have the projector serviced.

13.This product is capable of displaying inverted images for ceiling mount installation.

Please use BenQ’s Ceiling Mount Kit for mounting the unit and ensure it is securely installed.

4 Important safety instructions

Image 10

Contents Welcome Copyright DisclaimerTable of contents Iv Table of contents Supported timing for Component-YPbPr inputTable of contents Regulation StatementsMemo Vi Table of contents But could fail if power cuts or surges Important safety instructionsRefer servicing to qualified service personnel Important safety instructionsSafety Instructions Bedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Projector exterior viewFront / upper side Lower sideMation Controls and functionsExternal control panel Turns the projector on or offFreeze Remote controlAdjusts the focus of the projected image 5Up, 6 Down 3Left, Right4Pull out the battery holder Remote control effective rangeReplacing the remote control battery Push the holder into the remote controlPositioning your projector Choosing a locationObtaining a preferred projected image size Positioning your projector 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500Connecting a computer Connecting a computer or monitorConnection Connecting a monitor Connecting Video source devices Best video qualityConnecting a Component Video source device 1080i 50/ 60 HzConnecting an S-Video source device Device Video cable Audio cablesConnecting a composite Video source device Operation Utilizing the password functionTo set a password Start upTo change the password If you forget the passwordTo enter the password recall procedure Password set-up and return to the on-screen menuAuto-adjusting the image Adjusting the heightFine-tuning the image size and clarity Correcting keystone For exampleSwitching input signal Selecting an application modeHiding the image Remote paging operations Power indicator light flashesDisconnect the power cord from the wall socket Freezing the imageMenu operation Menu systemPicture menu Using the menusKeystone Picture menu Selected Color TempDepends on BrightnessPro-Picture menu Setting menu Advance menu Auto Off off Mode offHigh Altitude EconomicInformation menu ResolutionMode Equivalent SourceMaintenance Care of the projectorCalculation of lamp hour Lamp informationMessage Status Replacing the lamp Page Tighten the screw that secures the lamp Temperature informationResetting the lamp counter Restart the projectorLight Status & Description Power Temp Lamp Lamp events IndicatorsLight Status & Description Power Temp Lamp Power events Projector is under normal operationLight Status & Description Power Temp Lamp Thermal events For assistanceMaintenance Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Cause RemedySpecifications Projector specificationsSupported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsLimited Warranty WarrantyWarranty EEC statement Regulation StatementsFCC statement MIC statement