BenQ MP620p user manual

Page 45

4.Disconnect the lamp connector from the projector.

5.Loosen the screw that secures the lamp.

6.Pull the lamp from the projector.

• Pulling it too quickly may cause the lamp to break and scatter broken glass in the projector.

•Do not place the lamp in locations where water might splash on it, children can reach it, or near flammable materials.

•Do not insert your hands into the projector after the lamp is removed. If you touch the optical components inside, it could cause color unevenness and distortion of the projected images.

7.As shown in the figure, hold the new lamp and align the two locators on the lamp with the holes on the projector, and then insert the lamp all the way into the projector.

8.Connect the lamp connector to the projector.

Maintenance 39

Image 45

Contents Welcome Disclaimer CopyrightTable of contents Supported timing for Component-YPbPr input Iv Table of contentsRegulation Statements Table of contentsMemo Vi Table of contents Refer servicing to qualified service personnel Important safety instructionsBut could fail if power cuts or surges Important safety instructionsSafety Instructions Bedding or any other soft surface Safety Instructions Projector features IntroductionIntroduction Shipping contents Front / upper side Projector exterior viewRear side Lower sideExternal control panel Controls and functionsMation Turns the projector on or offAdjusts the focus of the projected image Remote controlFreeze 5Up, 6 Down 3Left, Right4Replacing the remote control battery Remote control effective rangePull out the battery holder Push the holder into the remote controlChoosing a location Positioning your projectorObtaining a preferred projected image size Positioning your projector Screen Center of lens Projection distance Maximum zoom Minimum zoom1219 1500Connecting a computer or monitor Connecting a computerConnection Connecting a monitor Best video quality Connecting Video source devices1080i 50/ 60 Hz Connecting a Component Video source deviceDevice Video cable Audio cables Connecting an S-Video source deviceConnecting a composite Video source device To set a password Utilizing the password functionOperation Start upTo enter the password recall procedure If you forget the passwordTo change the password Password set-up and return to the on-screen menuAdjusting the height Auto-adjusting the imageFine-tuning the image size and clarity For example Correcting keystoneSelecting an application mode Switching input signalHiding the image Disconnect the power cord from the wall socket Power indicator light flashesRemote paging operations Freezing the imageMenu system Menu operationUsing the menus Picture menuKeystone Picture menu Depends on Color TempSelected BrightnessPro-Picture menu Setting menu Advance menu High Altitude Mode offAuto Off off EconomicMode Equivalent ResolutionInformation menu SourceCare of the projector MaintenanceLamp information Calculation of lamp hourMessage Status Replacing the lamp Page Resetting the lamp counter Temperature informationTighten the screw that secures the lamp Restart the projectorLight Status & Description Power Temp Lamp Power events IndicatorsLight Status & Description Power Temp Lamp Lamp events Projector is under normal operationFor assistance Light Status & Description Power Temp Lamp Thermal eventsMaintenance Plug the power cord into the AC inlet on TroubleshootingMake sure that it is switched on Cause RemedyProjector specifications SpecificationsSupported timing for PC input Timing chartSupported timing for Component-YPbPrinput Supported timing for Video and S-Video inputsUnit mm Specifications DimensionsWarranty Limited WarrantyWarranty FCC statement Regulation StatementsEEC statement MIC statement