BenQ MP620p user manual Connecting a composite Video source device

Page 26

Connecting a composite Video source device

Examine your Video source device to determine if it has a set of unused composite Video output sockets available:

•If so, you can continue with this procedure.

•If not, you will need to reassess which method you can use to connect to the device. To connect the projector to an composite Video source device:

1.Take the (optional accessory) Video cable and connect one end to the composite Video output socket of the Video source device.

2.Connect the other end of the Video cable to the VIDEO socket on the projector.

The final connection path should be like that shown in the following diagram:

A/V device

Audio cables

Video cable

•The projector is only capable of playing mixed mono audio, even if a stereo audio input is connected. See "Connecting Audio" on page 17 for details.

•If the selected video image is not displayed after the projector is turned on and the correct video source has been selected, check that the Video source device is turned on and operating correctly. Also check that the signal cables have been connected correctly.

•You need only connect to this device using a composite Video connection if Component Video and S-Video inputs are unavailable for use. See "Connecting Video source devices" on page 17 for details.

20 Connection

Image 26

Contents Welcome Copyright DisclaimerTable of contents Iv Table of contents Supported timing for Component-YPbPr inputTable of contents Regulation StatementsMemo Vi Table of contents But could fail if power cuts or surges Important safety instructionsRefer servicing to qualified service personnel Important safety instructionsSafety Instructions Bedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Projector exterior viewFront / upper side Lower sideMation Controls and functionsExternal control panel Turns the projector on or offFreeze Remote controlAdjusts the focus of the projected image 5Up, 6 Down 3Left, Right4Pull out the battery holder Remote control effective rangeReplacing the remote control battery Push the holder into the remote controlPositioning your projector Choosing a locationObtaining a preferred projected image size Positioning your projector 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500Connection Connecting a computer or monitorConnecting a computer Connecting a monitor Connecting Video source devices Best video qualityConnecting a Component Video source device 1080i 50/ 60 HzConnecting an S-Video source device Device Video cable Audio cablesConnecting a composite Video source device Operation Utilizing the password functionTo set a password Start upTo change the password If you forget the passwordTo enter the password recall procedure Password set-up and return to the on-screen menuFine-tuning the image size and clarity Adjusting the heightAuto-adjusting the image Correcting keystone For exampleHiding the image Selecting an application modeSwitching input signal Remote paging operations Power indicator light flashesDisconnect the power cord from the wall socket Freezing the imageMenu operation Menu systemKeystone Using the menusPicture menu Picture menu Selected Color TempDepends on BrightnessPro-Picture menu Setting menu Advance menu Auto Off off Mode offHigh Altitude EconomicInformation menu ResolutionMode Equivalent SourceMaintenance Care of the projectorMessage Status Lamp informationCalculation of lamp hour Replacing the lamp Page Tighten the screw that secures the lamp Temperature informationResetting the lamp counter Restart the projectorLight Status & Description Power Temp Lamp Lamp events IndicatorsLight Status & Description Power Temp Lamp Power events Projector is under normal operationLight Status & Description Power Temp Lamp Thermal events For assistanceMaintenance Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Cause RemedySpecifications Projector specificationsSupported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsWarranty WarrantyLimited Warranty EEC statement Regulation StatementsFCC statement MIC statement