BenQ MP620p user manual Using the menus, Picture menu, Keystone

Page 34

Using the menus

The projector is equipped with on-screen display (OSD) menus for making various adjustments and settings.

There are 17 different menu languages. (Refer to page "4. Advance menu" on page 33 for more details.)

The following example describes the adjustment of the keystone.

1. Press 6Menu on the projector or Menu 4.			Adjust keystone values by
on the remote control to turn the on-			pressing Left 3/ Right 4on the
screen menu on.			projector or Left 3/ Right 4on
			the remote control.
			the remote control.

2.	Use 3Left/ Right 4on the projector or		5.	Press5Exit on the projector or
	Left 3/ Right 4on the remote control			press Menu twice* on the
	to select the	Picture menu.		remote control to leave and save

				the setting.

3.	Press 5Exit or 6Menu on the projector		*The first press leads you back to the
	or 6/ 5on the remote control to select
			submenu and the second press closes

	Keystone.	the on-screen menu.
	Keystone.

28 Operation

Image 34

Contents Welcome Copyright DisclaimerTable of contents Iv Table of contents Supported timing for Component-YPbPr inputTable of contents Regulation StatementsMemo Vi Table of contents But could fail if power cuts or surges Important safety instructionsRefer servicing to qualified service personnel Important safety instructionsSafety Instructions Bedding or any other soft surface Safety Instructions Introduction Projector featuresIntroduction Shipping contents Rear side Projector exterior viewFront / upper side Lower sideMation Controls and functionsExternal control panel Turns the projector on or offFreeze Remote controlAdjusts the focus of the projected image 5Up, 6 Down 3Left, Right4Pull out the battery holder Remote control effective rangeReplacing the remote control battery Push the holder into the remote controlPositioning your projector Choosing a locationObtaining a preferred projected image size Positioning your projector 1219 Maximum zoom Minimum zoomScreen Center of lens Projection distance 1500Connecting a computer Connecting a computer or monitorConnection Connecting a monitor Connecting Video source devices Best video qualityConnecting a Component Video source device 1080i 50/ 60 HzConnecting an S-Video source device Device Video cable Audio cablesConnecting a composite Video source device Operation Utilizing the password functionTo set a password Start upTo change the password If you forget the passwordTo enter the password recall procedure Password set-up and return to the on-screen menuAuto-adjusting the image Adjusting the heightFine-tuning the image size and clarity Correcting keystone For exampleSwitching input signal Selecting an application modeHiding the image Remote paging operations Power indicator light flashesDisconnect the power cord from the wall socket Freezing the imageMenu operation Menu systemPicture menu Using the menusKeystone Picture menu Selected Color TempDepends on BrightnessPro-Picture menu Setting menu Advance menu Auto Off off Mode offHigh Altitude EconomicInformation menu ResolutionMode Equivalent SourceMaintenance Care of the projectorCalculation of lamp hour Lamp informationMessage Status Replacing the lamp Page Tighten the screw that secures the lamp Temperature informationResetting the lamp counter Restart the projectorLight Status & Description Power Temp Lamp Lamp events IndicatorsLight Status & Description Power Temp Lamp Power events Projector is under normal operationLight Status & Description Power Temp Lamp Thermal events For assistanceMaintenance Make sure that it is switched on TroubleshootingPlug the power cord into the AC inlet on Cause RemedySpecifications Projector specificationsSupported timing for Component-YPbPrinput Timing chartSupported timing for PC input Supported timing for Video and S-Video inputsDimensions Unit mm SpecificationsLimited Warranty WarrantyWarranty EEC statement Regulation StatementsFCC statement MIC statement

Using the menus

Picture menu.

Keystone.