Connect
1.Switch on the router and switch on its DHCP setting.
2.With the ethernet cable, connect the router to the TV.
Alternatively, you can also connect the router to the TV wirelessly, through a
wireless USB adaptor (not included). See Connect your TV > Computers and the
Internet > Wireless LAN ready (Page 53).
3.Press 
, select [Setup] > [Connect to network], then press OK.
4.Follow the onscreen instructions to install the network.
5.Wait for the TV to find the network connection.
6.If you are prompted, agree to the End User License Agreement.
Wireless LAN ready
This TV is Wireless LAN ready. With the Wireless LAN adapter PTA01 accessory (sold separately), you can connect the TV to your home network wirelessly. You can enjoy the best of the web from Net TV services, and sharing of content between your devices connected to the home network using
Note:
∙The wireless network operates in the same 2.4GHz frequency spectrum as common household devices, such as Dect phones, microwave ovens or Bluetooth devices, which can cause Wi- Fi interferences. Move these devices away from the TV with the connected Wireless USB adapter.
∙You should turn off any unused network equipment in the home network as this increases network traffic.
∙Reception quality is dependent on the location of the wireless router, as well as the quality of services provided by the local Internet Service Provider.
∙When playing video over your wireless home network, we recommend that you use an IEEE 802.11 N router. The connection speed may differ according to the operating environment of your wireless home network.
Make your TV wireless
1.Switch on your wireless network router.
2.Insert the USB adapter PTA01 into the USB connection at the side of the TV. The wireless installation starts automatically.
3.Follow the on screen instructions. WPS -
If your router supports WPS
the router. Return to the TV in 2 minutes, select [WPS] and press OK. The TV
connects to your network. This takes about 2 minutes. Complete the installation.
Most new wireless routers have the WPS system and carry the WPS logo. The WPS system uses WPA security encryption and cannot be combined with devices on your network that use the WEP security
encryption. If you still need this WEP device in your network, install with [Scan] >
[Custom].
Scan for routers
If you have several routers in your network, you can select the network you need. To
select a specific network router, press [Scan]on the first page of the installation.
The routers with WPS and the strongest signal are shown first in the list on screen.
Select the router you need. If you are connecting a WPS router, select [WPS] on
the TV.
∙If you have set the PIN code in your router software, select [WPS pincode:] and enter the code.
EN 53
English