English
Infrared remote control
Loading the batteries
1Open the battery compartment cover.
2Insert two 'AA'
3Close the cover.
Caution: Do not mix old and new batteries. Also never mix different types of batteries (standard, alkaline, etc.)
Selecting the remote control code
|
|
|
| ● Simultaneously press |
ZOOM |
| DISPLAY |
| DISPLAY and 1 or 2 on the |
| ANGLE |
|
| remote control to select code 1 |
VOL |
|
| CH |
MUTE | or 2. |
➤The remote control will now be set to the remote control code of your choice.
➤This action can be repeated whenever necessary.
Remote control device code
To operate the player via the remote control without response from a second DVD player, you can program both player and remote control to use a second set of remote control codes.
The default system code is Code 1.
Programming the player to respond to Code 2
1Press ON/OFF to switch off the player.
2Simultaneously press SOUND MODE and / OPEN/CLOSE on the player for three seconds and then press ON/OFF to switch the player on again.
➤The player will now be programmed to respond to Code 2.
➤When steps 1 and 2 are repeated the system code is set to Code 1 again.
22PREPARATION